Difficulty

Difficult

Steps

10

Time Required

                          20 minutes

Sections

5

  • Battery
  • 2 steps
  • Front/Back Panels
  • 3 steps
  • Lens
  • 1 step
  • LCD Screen
  • 3 steps
  • Motherboard
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSony Cybershot DSC-W80

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Open the battery cover by sliding it towards you.

Open the battery cover by sliding it towards you.

1024

Step 2

  • Push the purple latch with your thumb to unlock the battery.
  • Pull the battery out.

Push the purple latch with your thumb to unlock the battery.

Pull the battery out.

Step 3

              Front/Back Panels
  • Remove the eight Phillips #000 screws.

Remove the eight Phillips #000 screws.

Step 4

  • Remove the single Phillips #000 screw found next to the battery latch.

Remove the single Phillips #000 screw found next to the battery latch.

Step 5

  • Remove the middle panel on the side of the device.
  • Slowly pry the camera apart at its seem.

Remove the middle panel on the side of the device.

Slowly pry the camera apart at its seem.

Step 6

              Lens
  • Disconnect all ribbon cables by using the flat end of a spudger to lift up the black tabs on the ZIF connectors.
  • Once disconnected, use your fingers to lift lens out of the frame.

Disconnect all ribbon cables by using the flat end of a spudger to lift up the black tabs on the ZIF connectors.

Once disconnected, use your fingers to lift lens out of the frame.

Step 7

              LCD Screen
  • Lift the power button board up off of the daughterboard.

Lift the power button board up off of the daughterboard.

Step 8

  • Remove the single Phillips #000 screw.
  • Use your hands to remove the blue daughterboard.

Remove the single Phillips #000 screw.

Use your hands to remove the blue daughterboard.

Step 9

  • Flip the camera around.
  • Remove the black and orange ribbon cables.

Flip the camera around.

Remove the black and orange ribbon cables.

Step 10

              Motherboard
  • Remove the two remaining ribbon cables.
  • Pull the motherboard from the camera.

Remove the two remaining ribbon cables.

Pull the motherboard from the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Saiman Sigdel

Member since: 02/21/2018

167 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       University of North Texas, Team S1-G4, Thompson Spring 2018                        

                                                  Member of University of North Texas, Team S1-G4, Thompson Spring 2018 



                    UNT-THOMPSON-S18S1G4                     


                                            4 Members                     


                                            10 Guides authored