Sony Dsc Rx10M3 Back And Right Panel Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 minutes            

Sections

2

• Battery Replacement
• 2 steps
• Back and Right Panel
• 6 steps

Flags

0

• BackSony DSC-RX10M3

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery Replacement               

• Turn off the Device by scrolling the tab to “OFF” indicated by the arrow.

Turn off the Device by scrolling the tab to “OFF” indicated by the arrow.

1024

Step 2

• Remove the battery located at the bottom of the device.

Remove the battery located at the bottom of the device.

Step 3

              Back and Right Panel               

• Remove the twelve 0.7mm Phillips #000 screws from the bottom case.

Remove the twelve 0.7mm Phillips #000 screws from the bottom case.

Step 4

• Remove the two 0.7mm screws that secure the right side of the camera.
• Remove the two 0.7mm screws that secure the left side of the camera, near the Wi-Fi logo and charging port.

Remove the two 0.7mm screws that secure the right side of the camera.

Remove the two 0.7mm screws that secure the left side of the camera, near the Wi-Fi logo and charging port.

Step 5

• Gently pull off the plastic eye guard.

Gently pull off the plastic eye guard.

Step 6

• Use a Phillips #000 screwdriver to remove the four 0.4mm screws located under the rubber eye guard.
• Use a plastic opening tool to detach the back panel of the camera.

Use a Phillips #000 screwdriver to remove the four 0.4mm screws located under the rubber eye guard.

Use a plastic opening tool to detach the back panel of the camera.

Step 7

• This is a tight spot; make sure you use minimal force when removing the cover.
• Using tweezers, disconnect the ribbon cable connecting the LCD to the circuit board.

This is a tight spot; make sure you use minimal force when removing the cover.

Using tweezers, disconnect the ribbon cable connecting the LCD to the circuit board.

Step 8

• This step is only needed if you wish to remove the right side panel.
• Use a plastic openeing tool to gently detach the right panel.

This step is only needed if you wish to remove the right side panel.

Use a plastic openeing tool to gently detach the right panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Salman Hersi                     

Member since: 01/14/2020

300 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       York University, Team S4-G4, Woodhouse Winter 2020                        

                                                  Member of York University, Team S4-G4, Woodhouse Winter 2020 



                    YORK-WOODHOUSE-W20S4G4                     


                                            3 Members                     


                                            6 Guides authored