Sony Dsc Rx10M3 Viewfinder Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Back and Right Panel
6 steps
Viewfinder
2 steps

Flags

BackSony DSC-RX10M3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

For this guide, you are not required to remove the side panel in step 6.

What you need

Step 1

              Back and Right Panel

Remove the twelve 0.7mm Phillips #000 screws from the bottom case.

Remove the twelve 0.7mm Phillips #000 screws from the bottom case.

1024

Step 2

Remove the two 0.7mm screws that secure the right side of the camera.
Remove the two 0.7mm screws that secure the left side of the camera, near the Wi-Fi logo and charging port.

Remove the two 0.7mm screws that secure the right side of the camera.

Remove the two 0.7mm screws that secure the left side of the camera, near the Wi-Fi logo and charging port.

Step 3

Gently pull off the plastic eye guard.

Gently pull off the plastic eye guard.

Step 4

Use a Phillips #000 screwdriver to remove the four 0.4mm screws located under the rubber eye guard.
Use a plastic opening tool to detach the back panel of the camera.

Use a Phillips #000 screwdriver to remove the four 0.4mm screws located under the rubber eye guard.

Use a plastic opening tool to detach the back panel of the camera.

Step 5

This is a tight spot; make sure you use minimal force when removing the cover.
Using tweezers, disconnect the ribbon cable connecting the LCD to the circuit board.

This is a tight spot; make sure you use minimal force when removing the cover.

Using tweezers, disconnect the ribbon cable connecting the LCD to the circuit board.

Step 6

This step is only needed if you wish to remove the right side panel.
Use a plastic openeing tool to gently detach the right panel.

This step is only needed if you wish to remove the right side panel.

Use a plastic openeing tool to gently detach the right panel.

Step 7

              Viewfinder

Using a Phillips #000 screwdriver, remove the silver 0.5mm screw.

Using a Phillips #000 screwdriver, remove the silver 0.5mm screw.

Step 8

Use tweezers to detach the ribbon cable from the motherboard.
Use upward force when removing the ribbon cable.

Use tweezers to detach the ribbon cable from the motherboard.

Use upward force when removing the ribbon cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Salman Hersi

Member since: 01/14/2020

300 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       York University, Team S4-G4, Woodhouse Winter 2020                        

                                                  Member of York University, Team S4-G4, Woodhouse Winter 2020 



                    YORK-WOODHOUSE-W20S4G4                     


                                            3 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team