Difficulty
Moderate
Steps
9
Time Required
30 minutes
Sections
2
- Battery
- 3 steps
- Keypad
- 6 steps
Flags
1
Mismatched Prerequisites
This guide does not have a proper prerequisite guide. Help match it to its ideal partner by finding it or writing one!
BackSony Ericsson S710a
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the back cover by sliding it off.
Remove the back cover by sliding it off.
1024
Step 2
- Pull the battery out using your finger.
Pull the battery out using your finger.
Step 3
- The battery can now be replaced.
- The battery is a 780 mAh rechargeable Lithium Ion battery.
The battery can now be replaced.
The battery is a 780 mAh rechargeable Lithium Ion battery.
Step 4
Keypad
- Remove the four screws using a Phillips #00 screwdriver.
Remove the four screws using a Phillips #00 screwdriver.
Step 5
- Remove the plastic cover with the iFixit opening tool.
- It is easiest to begin at the SD card slot and alternate prying the cover on opposite sides.
- The cover will not come off completely, because there are additional screws that need to be removed, but will pry loose up to the camera.
Remove the plastic cover with the iFixit opening tool.
It is easiest to begin at the SD card slot and alternate prying the cover on opposite sides.
The cover will not come off completely, because there are additional screws that need to be removed, but will pry loose up to the camera.
Step 6
- Using the iFixit opening tool, pry off the plastic piece at the bottom of the keypad.
- This piece is fixed with an adhesive, so you must break the bond to reach the screws underneath. It may be necessary to use additional adhesive during reassembly.
Using the iFixit opening tool, pry off the plastic piece at the bottom of the keypad.
This piece is fixed with an adhesive, so you must break the bond to reach the screws underneath. It may be necessary to use additional adhesive during reassembly.
Step 7
- Remove two 6 mm screws from beneath the previously removed plastic cover using a Phillips #00 screwdriver.
- Completely remove the back plastic cover.
Remove two 6 mm screws from beneath the previously removed plastic cover using a Phillips #00 screwdriver.
Completely remove the back plastic cover.
Step 8
- Pry the board from the plastic case using the iFixit opening tool.
- This part is tricky. The black plastic pieces at the base of the phone hold the board in.
Pry the board from the plastic case using the iFixit opening tool.
This part is tricky. The black plastic pieces at the base of the phone hold the board in.
Step 9
- After removing the board, you will see the plastic keyboard beneath. This can be removed by hand and is very flexible.
- You have successfully removed the keypad. You can clean, decorate, or replace the keyboard without worrying about damaging the phone.
After removing the board, you will see the plastic keyboard beneath. This can be removed by hand and is very flexible.
You have successfully removed the keypad. You can clean, decorate, or replace the keyboard without worrying about damaging the phone.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Alexander
Member since: 10/29/2011
75 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
University of Maryland, Team 1-1, Calloway Fall 2011
Member of University of Maryland, Team 1-1, Calloway Fall 2011
UMD-CALLOWAY-F11S1G1
3 Members
14 Guides authored