Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Logic Board
  • 4 steps
  • Touchscreen Glass Digitizer
  • 2 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackSony Ericsson Xperia X10

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Please SUBSCRIBE to my channel ツ

What you need

Video Overview

Step 1

              Logic Board
  • Switch-off the phone.
  • Remove the battery.
  • Unscrew 8x T6 Torx screws.

Switch-off the phone.

Remove the battery.

Unscrew 8x T6 Torx screws.

1024

Step 2

  • Use a Plastic Pry or other plastic tool to unhook the back housing / bezel and remove it.
  • Tip - try prying it open from the top and over to the side. It can be very tight if you are doing this for the first time. The volume rocker and camera button are not part of the housing, so try going around it.

Use a Plastic Pry or other plastic tool to unhook the back housing / bezel and remove it.

Tip - try prying it open from the top and over to the side. It can be very tight if you are doing this for the first time. The volume rocker and camera button are not part of the housing, so try going around it.

Step 3

  • Remove the Volume Up/Down and Camera buttons.
  • Unhook the SIM & SD Card reader unit and disconnect the flex cable.

Remove the Volume Up/Down and Camera buttons.

Unhook the SIM & SD Card reader unit and disconnect the flex cable.

Step 4

  • Remove the Audio jack connector.
  • Disconnect 4x flex cables:
  • LCD Display
  • Menu buttons
  • Touchscreen
  • Earpiece, Volume & Power On buttons
  • Carefully remove the mother board.
  • Please SUBSCRIBE to my channel ツ

Remove the Audio jack connector.

Disconnect 4x flex cables:

LCD Display

Menu buttons

Touchscreen

Earpiece, Volume & Power On buttons

Carefully remove the mother board.

Step 5

              Touchscreen Glass Digitizer
  • Use a heat gun or a hairdryer and warm the glass.
  • With a cutter carefully make a room between the glass and the frame to insert a Plastic Pick.
  • Slowly separate the Touchscreen from the frame.

Use a heat gun or a hairdryer and warm the glass.

With a cutter carefully make a room between the glass and the frame to insert a Plastic Pick.

Slowly separate the Touchscreen from the frame.

Step 6

  • When you are installing the new Touchscreen you must use an adhesive tape.
  • .
  • Please SUBSCRIBE to my channel ツ

When you are installing the new Touchscreen you must use an adhesive tape.

.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    ZFix

Member since: 12/09/2013

187,195 Reputation

                                      330 Guides authored                  



                       Badges:
                       35







                                                        +32 more badges

Team

                       Master Techs                        

                                                  Member of Master Techs 



                    Community                     


                                            310 Members                     


                                            1,168 Guides authored