Difficulty
Moderate
Steps
5
Time Required
15 minutes
Sections
1
- Battery and Battery Contacts
- 5 steps
Flags
0
BackSony FDL-220R Watchman
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove battery cover and batteries
- Press down on the textured area and push towards the bottom of the device.
- Gently remove the battery cover.
- Remove the three AA batteries.
Press down on the textured area and push towards the bottom of the device.
Gently remove the battery cover.
Remove the three AA batteries.
1024
Step 2
Inspect battery contacts in battery compartment
- Inspect battery contacts for any signs of damage.
- Clean battery contacts with a solution of warm water and baking soda if there is corrosion.
Inspect battery contacts for any signs of damage.
Clean battery contacts with a solution of warm water and baking soda if there is corrosion.
Step 3
Remove screws
- Locate the five 5x11mm screws surrounding the battery compartment.
- Remove screws with a Phillips #00 screwdriver.
Locate the five 5x11mm screws surrounding the battery compartment.
Remove screws with a Phillips #00 screwdriver.
Step 4
Remove back casing
- Grasp the entire back half of the Watchman’s casing.
- Snap off casing from the bottom of the device.
- Gently pull off entire back casing.
- Buttons may fall out upon opening casing. See the button replacement guide to fix buttons.
Grasp the entire back half of the Watchman’s casing.
Snap off casing from the bottom of the device.
Gently pull off entire back casing.
Buttons may fall out upon opening casing. See the button replacement guide to fix buttons.
Step 5
Inspect battery contacts on inside of back cover
- Inspect the two small springs on the back of the battery compartment.
- Clean contacts with a solution of warm water and baking soda if there is corrosion.
Inspect the two small springs on the back of the battery compartment.
Clean contacts with a solution of warm water and baking soda if there is corrosion.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Sam Putnam
Member since: 10/22/2014
484 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Baylor, Team 4-5, Williams Fall 2014
Member of Baylor, Team 4-5, Williams Fall 2014
BU-WILLIAMS-F14S4G5
4 Members
4 Guides authored
