Difficulty
Moderate
Steps
5
Time Required
10 minutes
Sections
1
- Buttons
- 5 steps
Flags
0
BackSony FDL-220R Watchman
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove battery cover and batteries
- Press down on the textured area and push towards the bottom of the device.
- Gently remove the battery cover.
- Remove the three AA batteries.
Press down on the textured area and push towards the bottom of the device.
Gently remove the battery cover.
Remove the three AA batteries.
1024
Step 2
Remove screws
- Locate the five 5x11mm screws surrounding the battery compartment.
- Remove screws with a Philips #00 screwdriver.
Locate the five 5x11mm screws surrounding the battery compartment.
Remove screws with a Philips #00 screwdriver.
Step 3
Remove back casing
- Grasp the entire back half of the Watchman’s casing.
- Snap off the casing from the bottom of the device.
- Gently pull off entire back casing.
Grasp the entire back half of the Watchman’s casing.
Snap off the casing from the bottom of the device.
Gently pull off entire back casing.
Step 4
Remove circuit board
- Carefully grasp the entire circuit board.
- Pull the circuit board off of the device’s plastic casing.
Carefully grasp the entire circuit board.
Pull the circuit board off of the device’s plastic casing.
Step 5
Remove/Replace Buttons
- Locate the thee plastic buttons/switches on the sides of the plastic grey casing.
- Buttons/switches should be simply resting in their slots on the device.
- Remove all three buttons/switches.
- If the buttons/switches are dirty, clean them in warm water and dry thoroughly.
- If one of the buttons/switches is broken, simply replace it with a new one.
- When replacing, make sure that the slot on the switches faces up.
Locate the thee plastic buttons/switches on the sides of the plastic grey casing.
Buttons/switches should be simply resting in their slots on the device.
Remove all three buttons/switches.
If the buttons/switches are dirty, clean them in warm water and dry thoroughly.
If one of the buttons/switches is broken, simply replace it with a new one.
When replacing, make sure that the slot on the switches faces up.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Sam Putnam
Member since: 10/22/2014
484 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Baylor, Team 4-5, Williams Fall 2014
Member of Baylor, Team 4-5, Williams Fall 2014
BU-WILLIAMS-F14S4G5
4 Members
4 Guides authored