Difficulty
Easy
Steps
2
Time Required
3 minutes
Sections
1
- Right Ear Pad
- 2 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSony H.ear on 3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
(You might see tape on the headphone arches in photos. This is because my headphones have broken along this casing and while disassembling, it simplifies repair to keep that area fixed together.)
Note: This guide used to be for both ear pads but I decided to make it just for one and make the other it’s own guide to make all the guides for these headphones easier to read and work with.
What you need
Step 1
Extend the Right Speaker
- Extend the Right cup and fold the Left cup away via the headband .
- This will help protect the other ear pad while you work on this one.
Extend the Right cup and fold the Left cup away via the headband .
This will help protect the other ear pad while you work on this one.
1024
Step 2
Unclip the Right Ear Pad
- The pad is attached by 6 clips in a hexagonal pattern, shown by the arrows.
- Starting from the top, insert an opening pick in between where the cup leather meets the plastic casing, push it in firmly, then twist it until you disengage the top clip.
- Try not to damage or peel off the leather while doing this. It helps if you pry towards the speaker housing, not the leather cup.
- Work round the back side, poking the pick in and twisting to disengage further clips until you can gently pull the cup away.
- When re-assembling, make sure that the stitching line on the ear pad is facing the bottom.
The pad is attached by 6 clips in a hexagonal pattern, shown by the arrows.
Starting from the top, insert an opening pick in between where the cup leather meets the plastic casing, push it in firmly, then twist it until you disengage the top clip.
Try not to damage or peel off the leather while doing this. It helps if you pry towards the speaker housing, not the leather cup.
Work round the back side, poking the pick in and twisting to disengage further clips until you can gently pull the cup away.
When re-assembling, make sure that the stitching line on the ear pad is facing the bottom.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Dzuk
Member since: 07/12/2021
1,221 Reputation
10 Guides authored
Badges:
11
+8 more badges