Sony Playstation 3D Display 3D Sync Transmitter Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          20 minutes            

Sections

2

• Rear Case
• 4 steps
• 3D Sync Transmitter
• 3 steps

Flags

0

• BackSony PlayStation 3D Display

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rear Case               

• Remove the base by pushing in the button and sliding out the unit.

Remove the base by pushing in the button and sliding out the unit.

1024

Step 2

• Remove USB port cover from back plate with a metal spudger.
• This will prevent the cover from falling under the back plate once it is removed.

Remove USB port cover from back plate with a metal spudger.

This will prevent the cover from falling under the back plate once it is removed.

Step 3

• With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.
• With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.
• These screws have different threads and need to be kept separate.

With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.

With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.

These screws have different threads and need to be kept separate.

Step 4

• Remove back plate with a plastic opening tool by slowing prying around the entire plate.
• Be gentle to avoid breaking the plastic clips which hold the plate.
• Once separated the plate easily lifts off.

Remove back plate with a plastic opening tool by slowing prying around the entire plate.

Be gentle to avoid breaking the plastic clips which hold the plate.

Once separated the plate easily lifts off.

Step 5

              3D Sync Transmitter               

• With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws that hold the 3D Sync Transmitter in place.

With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws that hold the 3D Sync Transmitter in place.

Step 6

• Carefully pry off the 3D Sync Transmitter with the plastic opening tool.
• Use the plastic opening tool to pry at both ends and not from the center as to avoid breaking the 3D Sync Transmitter.

Carefully pry off the 3D Sync Transmitter with the plastic opening tool.

Use the plastic opening tool to pry at both ends and not from the center as to avoid breaking the 3D Sync Transmitter.

Step 7

• Pry the tab slightly up with your thumbnail and pull the connector away from the board.

Pry the tab slightly up with your thumbnail and pull the connector away from the board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 7 other contributors 

                    Tia McNaughton                     

Member since: 10/01/2015

379 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team 12-16, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 12-16, Maness Fall 2015 



                    CPSU-MANESS-F15S12G16                     


                                            4 Members                     


                                            8 Guides authored