Sony Playstation 3D Display Power Port Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          20 minutes            

Sections

2

• Rear Case
• 4 steps
• Power Port
• 2 steps

Flags

0

• BackSony PlayStation 3D Display

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rear Case               

• Remove the base by pushing in the button and sliding out the unit.

Remove the base by pushing in the button and sliding out the unit.

1024

Step 2

• Remove USB port cover from back plate with a metal spudger.
• This will prevent the cover from falling under the back plate once it is removed.

Remove USB port cover from back plate with a metal spudger.

This will prevent the cover from falling under the back plate once it is removed.

Step 3

• With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.
• With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.
• These screws have different threads and need to be kept separate.

With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.

With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.

These screws have different threads and need to be kept separate.

Step 4

• Remove back plate with a plastic opening tool by slowing prying around the entire plate.
• Be gentle to avoid breaking the plastic clips which hold the plate.
• Once separated the plate easily lifts off.

Remove back plate with a plastic opening tool by slowing prying around the entire plate.

Be gentle to avoid breaking the plastic clips which hold the plate.

Once separated the plate easily lifts off.

Step 5

              Power Port               

• With the Phillips #02 screwdriver, remove the two 5mm length x 7mm head screws from the left and right side of the power port plate.

With the Phillips #02 screwdriver, remove the two 5mm length x 7mm head screws from the left and right side of the power port plate.

Step 6

• Remove the power port by depressing the white tab attached to the wires.

Remove the power port by depressing the white tab attached to the wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Logan Simon                     

Member since: 10/08/2015

234 Reputation

                                      1 Guide authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Cal Poly, Team 12-16, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 12-16, Maness Fall 2015 



                    CPSU-MANESS-F15S12G16                     


                                            4 Members                     


                                            8 Guides authored