Sony Srs Btx500 Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Battery
4 steps
Motherboard
4 steps

Flags

BackSony SRS-BTX500
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Locate the four rubber grips on the bottom of the speaker. Use the plastic opening tool to remove the grips, exposing the underlying screws.

Locate the four rubber grips on the bottom of the speaker. Use the plastic opening tool to remove the grips, exposing the underlying screws.

1024

Step 2

Using a Phillips #1 screwdriver, remove the four 5mm screws that were underneath the four rubber grips.

Using a Phillips #1 screwdriver, remove the four 5mm screws that were underneath the four rubber grips.

Step 3

Use the plastic opening tool to run along the outside edges of the speaker. Pry along the seams until you can remove the side panel of the speaker, exposing the battery.

Use the plastic opening tool to run along the outside edges of the speaker. Pry along the seams until you can remove the side panel of the speaker, exposing the battery.

Step 4

Use the plastic opening tool to remove the battery from casing.
Unclasp the battery from the speaker. Remove and replace.

Use the plastic opening tool to remove the battery from casing.

Unclasp the battery from the speaker. Remove and replace.

Step 5

              Motherboard

With the front of the speaker facing you, run the plastic opening tool along the bottom of the speaker. Then push the face of the speaker at both ends before lifting it off.

With the front of the speaker facing you, run the plastic opening tool along the bottom of the speaker. Then push the face of the speaker at both ends before lifting it off.

Step 6

Remove the two covers on the left and right with the small plastic opening tool to expose hidden screws.
Use a Phillips #1 screwdriver to remove the 14 indicated screws size 7mm.
Use a Phillips #1 screwdriver to remove the 8 indicated screws size 5mm.

Remove the two covers on the left and right with the small plastic opening tool to expose hidden screws.

Use a Phillips #1 screwdriver to remove the 14 indicated screws size 7mm.

Use a Phillips #1 screwdriver to remove the 8 indicated screws size 5mm.

Step 7

Lift off the casing on the left, right, and top of the speaker.

Lift off the casing on the left, right, and top of the speaker.

Step 8

Pull apart the speaker from the top. Unplug the indicated exposed wire that connects the speakers and the motherboard.
After the first wire is disconnected, separate the other connecting wires.

Pull apart the speaker from the top. Unplug the indicated exposed wire that connects the speakers and the motherboard.

After the first wire is disconnected, separate the other connecting wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors

                    Cody Moring

Member since: 01/29/2016

185 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of Alabama, Team 1-5, Sydow campbell Spring 2016                        

                                                  Member of University of Alabama, Team 1-5, Sydow campbell Spring 2016 



                    UA-SYDOW CAMPBELL-S16S1G5                     


                                            3 Members                     


                                            2 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team