Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

3

  • Battery
  • 4 steps
  • Speaker Panel
  • 2 steps
  • Speaker
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSony VAIO PCG-F360

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Position the laptop screen-side down as shown.
  • In this position the battery housing will be located on the right hand side.

Position the laptop screen-side down as shown.

In this position the battery housing will be located on the right hand side.

1024

Step 2

  • Lift the panel up and then out to gain access to the battery.

Lift the panel up and then out to gain access to the battery.

Step 3

  • Use the indentations to pull the old battery out.

Use the indentations to pull the old battery out.

Step 4

  • The battery is now removed and it is safe to move on to uninstalling other components.

The battery is now removed and it is safe to move on to uninstalling other components.

Step 5

              Speaker Panel
  • There are two screws on the left hand side of the laptop near the IR receiver. remove them using a #00 Philips head screwdriver.
  • Slide the speaker panel towards the left, then carefully flip it over onto the keyboard.
  • Make sure not to pull the speaker panel away from the computer just yet - it is still connected!

There are two screws on the left hand side of the laptop near the IR receiver. remove them using a #00 Philips head screwdriver.

Slide the speaker panel towards the left, then carefully flip it over onto the keyboard.

Make sure not to pull the speaker panel away from the computer just yet - it is still connected!

Step 6

  • Push the beige tab in the direction of the ribbon. it should only move a small amount
  • Remove the ribbon by gently pulling on it, there should be little or no resistance.
  • Now the speaker panel can be set aside.

Push the beige tab in the direction of the ribbon. it should only move a small amount

Remove the ribbon by gently pulling on it, there should be little or no resistance.

Now the speaker panel can be set aside.

Step 7

              Speaker
  • The two speakers are located on the ends of the panel.
  • There are two screws holding each speaker. Remove them using a #00 Philips head screw driver.

The two speakers are located on the ends of the panel.

There are two screws holding each speaker. Remove them using a #00 Philips head screw driver.

Step 8

  • Carefully flip the speaker over and replace or clean the needed parts.

Carefully flip the speaker over and replace or clean the needed parts.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Hannah Millea

Member since: 03/11/2014

401 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UMass Dartmouth, Team 3-5, Calaway Spring 2014                        

                                                  Member of UMass Dartmouth, Team 3-5, Calaway Spring 2014 



                    UMASSD-CALAWAY-S14S3G5                     


                                            2 Members                     


                                            4 Guides authored