Difficulty
Moderate
Steps
10
Time Required
25 minutes
Sections
4
- Battery
- 2 steps
- Back Panel
- 2 steps
- Multimedia Card
- 3 steps
- Multimedia Card Reader
- 3 steps
Flags
0
BackSony Vaio SVT151A11L
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip the laptop over so that the battery on the underside of the device is revealed.
- Unscrew the two 11mm slotted silver screws that can be found at the top of the battery.
Flip the laptop over so that the battery on the underside of the device is revealed.
Unscrew the two 11mm slotted silver screws that can be found at the top of the battery.
1024
Step 2
- Wedge the plastic opening tool between the back panel and the battery on the top left side of the device.
- Push down on the plastic opening tool until the battery lifts from the back of the laptop.
- Grab the battery and remove it from the device.
Wedge the plastic opening tool between the back panel and the battery on the top left side of the device.
Push down on the plastic opening tool until the battery lifts from the back of the laptop.
Grab the battery and remove it from the device.
Step 3
Back Panel
- Unscrew the three 4mm screws using a JIS #0 screwdriver.
- Unscrew the eight 7 mm screws using a JIS #0 screwdriver.
- Grab and lift the edge of the panel to pull it free from the rest of the computer.
Unscrew the three 4mm screws using a JIS #0 screwdriver.
Unscrew the eight 7 mm screws using a JIS #0 screwdriver.
Grab and lift the edge of the panel to pull it free from the rest of the computer.
Step 4
- Grab the disk drive located at the edge of the computer and pull it it out.
- Unscrew the three 7 mm screws with a JIS #0 screwdriver.
Grab the disk drive located at the edge of the computer and pull it it out.
Unscrew the three 7 mm screws with a JIS #0 screwdriver.
Step 5
Multimedia Card
- Get unobstructed access to the multimedia card.
Get unobstructed access to the multimedia card.
Step 6
- Unscrew the two 2mm screws from the board using JIS #0 screwdriver.
Unscrew the two 2mm screws from the board using JIS #0 screwdriver.
Step 7
- Lift up multimedia card.
- Pull out ribbon cable from connected board.
Lift up multimedia card.
Pull out ribbon cable from connected board.
Step 8
Multimedia Card Reader
- Get unobstructed access to the multimedia card reader.
Get unobstructed access to the multimedia card reader.
Step 9
- Unscrew three 2mm screws using JIS #0 screwdriver.
Unscrew three 2mm screws using JIS #0 screwdriver.
Step 10
- Gently lift up multimedia card reader.
- Pull out ribbon cable from the board.
Gently lift up multimedia card reader.
Pull out ribbon cable from the board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Namuundari Zorigtbaatar
Member since: 10/18/2017
201 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team S4-G6, Julie Fall 2017
Member of UMass Dartmouth, Team S4-G6, Julie Fall 2017
UMASSD-JULIE-F17S4G6
2 Members
6 Guides authored