Difficulty
Moderate
Steps
11
Time Required
Suggest a time??
Sections
1
- LCD Screen
- 11 steps
Flags
0
BackSony Vaio VPCCB290X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LCD Screen
- First make sure the laptop is off and closed.
First make sure the laptop is off and closed.
1024
Step 2
- Unlock the battery and push the release lever to remove the battery from the laptop.
Unlock the battery and push the release lever to remove the battery from the laptop.
Step 3
- Remove the screws marked in red to remove the hard drive cover and the screws marked in blue to loosen the hard drive. Then gently slide the hard drive out.
Remove the screws marked in red to remove the hard drive cover and the screws marked in blue to loosen the hard drive. Then gently slide the hard drive out.
Step 4
- Remove all the screws that hold the plastic bottom on. There are some more screws that cant be seen in the photo.
Remove all the screws that hold the plastic bottom on. There are some more screws that cant be seen in the photo.
Step 5
- Gently pry up the plastic bottom and if it feels like it is resisting check the surrounding areas for more screws.
Gently pry up the plastic bottom and if it feels like it is resisting check the surrounding areas for more screws.
Step 6
- Now that the backing plate is off make sure to be careful of the Motherboard and its components from being damaged. from here on out it is recommended that you wear a anti static bracelet or at the very least touching something metal to remove any static electricity that you may have built up
Now that the backing plate is off make sure to be careful of the Motherboard and its components from being damaged. from here on out it is recommended that you wear a anti static bracelet or at the very least touching something metal to remove any static electricity that you may have built up
Step 7
- Use a common or lat head screw driver to gently untangle the wires from their paths.
Use a common or lat head screw driver to gently untangle the wires from their paths.
Step 8
- You will need to unscrew this small circuit board and fold it up to get the wires out from under it.
You will need to unscrew this small circuit board and fold it up to get the wires out from under it.
Step 9
- Disconnect the screen from the motherboard.
Disconnect the screen from the motherboard.
Step 10
- They are two hinges that hold the screen on. Make sure to pay attention to where the screws come from in order to put them back and to make installation easier.
They are two hinges that hold the screen on. Make sure to pay attention to where the screws come from in order to put them back and to make installation easier.
Step 11
- By folding up the hinges the screen will simply slide away from the body of the computer and you can then put the new screen into place.
By folding up the hinges the screen will simply slide away from the body of the computer and you can then put the new screen into place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Eric Martinez
Member since: 02/14/2017
616 Reputation
6 Guides authored
Badges:
8
+5 more badges
Team
USF Tampa, Team 20-5, Remmell Spring 2017
Member of USF Tampa, Team 20-5, Remmell Spring 2017
USFT-REMMELL-S17S20G5
3 Members
12 Guides authored
