Sony Vaio Vpcw21Fx Headphone Jack Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          45 minutes - 1 hour

Sections

Battery
3 steps
Headphone Jack
9 steps

Flags

BackSony Vaio VPCCW21FX
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Make sure your device is powered off and unplugged to avoid electric shock.
Place your device upside down with the bottom panel facing upwards.
Orient the device so the battery is away from you as shown

Make sure your device is powered off and unplugged to avoid electric shock.

Place your device upside down with the bottom panel facing upwards.

Orient the device so the battery is away from you as shown

1024

Step 2

Unlock the battery by sliding the lock switch to the right.
Locate the release latch. Slide the latch to the left to remove the battery from your laptop.
Be sure to lift up on the battery while you slide the latch to the left.

Unlock the battery by sliding the lock switch to the right.

Locate the release latch. Slide the latch to the left to remove the battery from your laptop.

Be sure to lift up on the battery while you slide the latch to the left.

Step 3

Remove the battery from your laptop.

Remove the battery from your laptop.

Step 4

              Headphone Jack

Place the laptop upside down with the bottom panel facing upwards.
Locate the screw that holds the small panel covering your laptop’s Ram. This panel should be in the dead center of your laptop.
Unscrew the screw and remove the panel.

Place the laptop upside down with the bottom panel facing upwards.

Locate the screw that holds the small panel covering your laptop’s Ram. This panel should be in the dead center of your laptop.

Unscrew the screw and remove the panel.

Step 5

Before you move away from where your RAM is located, be sure to unplug the wire labeled To MB. If you do not unplug this, the back panel you are trying to remove will not come off.

Before you move away from where your RAM is located, be sure to unplug the wire labeled To MB. If you do not unplug this, the back panel you are trying to remove will not come off.

Step 6

Next, locate the panel covering your laptop’s hard drive. This panel should be located on the lower right hand side of your laptop.
Unscrew the cover on the hard drive.
Remove the hard drive cover.

Next, locate the panel covering your laptop’s hard drive. This panel should be located on the lower right hand side of your laptop.

Unscrew the cover on the hard drive.

Remove the hard drive cover.

Step 7

Remove screws.
Remove screws and remove panel.

Remove screws.

Remove screws and remove panel.

Step 8

Remove the hard drive by gently pressing down on it and sliding it to the right.
Remember to have a clean work space to place the parts you take off your laptop. It’d be embarrassing to forget to reassemble a part or have a screw or two left over.

Remove the hard drive by gently pressing down on it and sliding it to the right.

Remember to have a clean work space to place the parts you take off your laptop. It’d be embarrassing to forget to reassemble a part or have a screw or two left over.

Step 9

Remove the screws holding the rest of the outside panel down.
Gently lift the panel up to remove it once all the screws have been removed.

Remove the screws holding the rest of the outside panel down.

Gently lift the panel up to remove it once all the screws have been removed.

Step 10

Once the back panel has been removed, set the rest of your laptop to the side and place the panel you just removed in front of you.
Locate the headphone jack, which will be in the top right hand corner of the panel. The headphone jack board is a bright green, you can’t miss it.

Once the back panel has been removed, set the rest of your laptop to the side and place the panel you just removed in front of you.

Locate the headphone jack, which will be in the top right hand corner of the panel. The headphone jack board is a bright green, you can’t miss it.

Step 11

Remove the screws holding the headphone jack board down.

Remove the screws holding the headphone jack board down.

Step 12

Gently pull the board to remove it.

Gently pull the board to remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Rebecca

Member since: 10/10/2016

324 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Sam Houston State, Team 12-6, Blackburne Fall 2016                        

                                                  Member of Sam Houston State, Team 12-6, Blackburne Fall 2016 



                    SHSU-BLACKBURNE-F16S12G6                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team