Difficulty

Moderate

Steps

12

Time Required

                          10 - 20 minutes

Sections

1

  • Power supply
  • 12 steps

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

  • BackSanyo pro extraX multiverse projector

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Bottom Panel
  • Place the projector upside-down to access the screws on the bottom.
  • Remove five 9mm long screws with a Phillips 1 screwdriver.

Place the projector upside-down to access the screws on the bottom.

Remove five 9mm long screws with a Phillips 1 screwdriver.

1024

Step 2

  • Turn the projector on its side.
  • Remove one 9mm Phillips 1 screw

Turn the projector on its side.

Remove one 9mm Phillips 1 screw

Step 3

  • Place the projector right side up and lift the top panel up and put it to the side.

Place the projector right side up and lift the top panel up and put it to the side.

Step 4

  • Locate the metal panel on the right hand side.
  • Remove two 7mm screws

Locate the metal panel on the right hand side.

Remove two 7mm screws

Step 5

  • Lift the panel up slightly and forward to remove it completely.

Lift the panel up slightly and forward to remove it completely.

Step 6

              Motherboard
  • Remove five 9mm screws with a Phillips 1 screwdriver
  • Remove one 11mm screws with a Phillips one screwdriver

Remove five 9mm screws with a Phillips 1 screwdriver

Remove one 11mm screws with a Phillips one screwdriver

Step 7

  • Remove two 5mm screws with a Phillips 2 screwdriver

Remove two 5mm screws with a Phillips 2 screwdriver

Step 8

  • Remove all clips from mother board.
  • There are two additional clips underneath the mother board that need to be disconnected as well.

Remove all clips from mother board.

There are two additional clips underneath the mother board that need to be disconnected as well.

Step 9

              ribbon cables
  • To remove the ribbon cables, lift up on the black hinge with a fingernail or the tip of your spudger.
  • Now, use a spudger or a barbecue skewer to lift the cable out.

To remove the ribbon cables, lift up on the black hinge with a fingernail or the tip of your spudger.

Now, use a spudger or a barbecue skewer to lift the cable out.

Step 10

  • Lift the board up slowly, making sure there are no snagged cables.
  • Unplug the two power cables coming into the board.
  • Remove the mother board from the device.

Lift the board up slowly, making sure there are no snagged cables.

Unplug the two power cables coming into the board.

Remove the mother board from the device.

Step 11

  • Remove two clips by pinching and pulling up on the connector.

Remove two clips by pinching and pulling up on the connector.

Step 12

  • You can now remove the power supply.

You can now remove the power supply.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Matt Block

Member since: 11/30/2017

256 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored