Difficulty

Easy

Steps

5

Time Required

                          15 minutes

Sections

2

  • Tires and Hubcaps
  • 2 steps
  • Motherboard
  • 3 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackSphero Ollie

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Tires and Hubcaps
  • Firmly grasp Ollie in one hand.
  • Remove the blue rubber tire in a peeling motion with your opposite hand.

Firmly grasp Ollie in one hand.

Remove the blue rubber tire in a peeling motion with your opposite hand.

1024

Step 2

  • Continue to firmly hold Ollie in one hand.
  • Use a Plastic Opening Tool to gently pry off the hubcap.
  • Avoid inserting the Plastic Opening Tool into the empty holes, but instead use the tool near the tabs holding the hubcap in.
  • Do not aim the hubcap towards another person as it may pop off with force.

Continue to firmly hold Ollie in one hand.

Use a Plastic Opening Tool to gently pry off the hubcap.

Avoid inserting the Plastic Opening Tool into the empty holes, but instead use the tool near the tabs holding the hubcap in.

Do not aim the hubcap towards another person as it may pop off with force.

Step 3

              Motherboard
  • Loosen and remove the 10mm screw on each side of the device using a JIS 1 screwdriver tip.
  • Remove the plastic tire frame from the device

Loosen and remove the 10mm screw on each side of the device using a JIS 1 screwdriver tip.

Remove the plastic tire frame from the device

Step 4

  • Loosen and remove the four 10mm Screws on the underside of the device using a JIS 1 tip.
  • Firmly grasp the bottom of the device and pull the top half of the outer case off of the bottom.

Loosen and remove the four 10mm Screws on the underside of the device using a JIS 1 tip.

Firmly grasp the bottom of the device and pull the top half of the outer case off of the bottom.

Step 5

  • Loosen and remove the 10mm screws holding the blue tooth connector as well as the two 1 10 screws holding the motherboard to the case using the JIS #1 screwdriver
  • Loosen and remove the 10mm screws holding the antenna to the case.
  • Gently remove mother board from the case with an upward motion.

Loosen and remove the 10mm screws holding the blue tooth connector as well as the two 1 10 screws holding the motherboard to the case using the JIS #1 screwdriver

Loosen and remove the 10mm screws holding the antenna to the case.

Gently remove mother board from the case with an upward motion.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Krystal Hedrick

Member since: 10/30/2017

352 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UW Tacoma, Team S1-G3, Rose Fall 2017                        

                                                  Member of UW Tacoma, Team S1-G3, Rose Fall 2017 



                    UWT-ROSE-F17S1G3                     


                                            4 Members                     


                                            5 Guides authored