Difficulty
Easy
Steps
8
Time Required
5 - 10 minutes
Sections
1
- Spring/coil
- 8 steps
Flags
0
BackiPhone Accessories
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Spring/coil
- Pull the phone holder off the mount by applying force; the parts will not actually break from the pressure. Temporarily remove the two round half-socket covers on the ball socket, as they are prone to slipping off.
Pull the phone holder off the mount by applying force; the parts will not actually break from the pressure. Temporarily remove the two round half-socket covers on the ball socket, as they are prone to slipping off.
1024
Step 2
- Remove four 5.0 mm screws from the backing panel of the phone holder using the Oval shape screwhead. Push out wing panels to release the mechanism, and remove the screws and holder from the backing panel.
Remove four 5.0 mm screws from the backing panel of the phone holder using the Oval shape screwhead. Push out wing panels to release the mechanism, and remove the screws and holder from the backing panel.
Step 3
- If either of the springs have not ejected from their slots, proceed to pull them out gently so that the chassis the wing panels are connected to remain undisturbed.
If either of the springs have not ejected from their slots, proceed to pull them out gently so that the chassis the wing panels are connected to remain undisturbed.
Step 4
- Insert two new 2.6 cm springs as you would batteries to a tv remote. Be cautious as to keep the chassis in place during this process.
Insert two new 2.6 cm springs as you would batteries to a tv remote. Be cautious as to keep the chassis in place during this process.
Step 5
- Pull out of the wing panels to re-engage the mechanism, holding the center of panels down.
- The backing panel will not be able to properly be reattached unless the mechanism is is engaged, and the springs are bunched.
Pull out of the wing panels to re-engage the mechanism, holding the center of panels down.
The backing panel will not be able to properly be reattached unless the mechanism is is engaged, and the springs are bunched.
Step 6
- Slide the backing panel over the frame of the holder, aligning the sides. Press the button on the center of the holder to once again disengage the mechanism. This will allow the panel to fully slide back into place.
Slide the backing panel over the frame of the holder, aligning the sides. Press the button on the center of the holder to once again disengage the mechanism. This will allow the panel to fully slide back into place.
Step 7
- Rescrew backing with oval head screwdriver to reassemble the phone holder’s backing.
Rescrew backing with oval head screwdriver to reassemble the phone holder’s backing.
Step 8
- With moderate to heavy force, apply pressure to the ball joint into the socket.
With moderate to heavy force, apply pressure to the ball joint into the socket.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Ramy Huynh
Member since: 09/30/2019
172 Reputation
1 Guide authored
Badges:
3
Team
CSU Fullerton, Team S1-G1, Bruce Fall 2019
Member of CSU Fullerton, Team S1-G1, Bruce Fall 2019
CSUF-BRUCE-F19S1G1
4 Members
1 Guide authored
