Difficulty

Easy

Steps

11

Time Required

                          5 minutes

Sections

2

  • Plastic Wing Replacement
  • 3 steps
  • Fur Replacement
  • 8 steps

Flags

0

  • BackSpin Master Hatchimal Draggle

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Plastic Wing Replacement
  • lay the Hatchimal on its side.

lay the Hatchimal on its side.

1024

Step 2

  • Using the plastic opening tool, push in on the purple clip.

Using the plastic opening tool, push in on the purple clip.

Step 3

  • Pull the wing off of the hatchimal.
  • The wing should come off with little resistance.

Pull the wing off of the hatchimal.

The wing should come off with little resistance.

Step 4

              Fur Replacement
  • Cut the fur retaining zip-tie with a pair of scissors.

Cut the fur retaining zip-tie with a pair of scissors.

Step 5

  • Lift the fur up until it can’t go further.

Lift the fur up until it can’t go further.

Step 6

  • Use the spudger tool to push up on the black clip to free it.
  • Pull the clip out.

Use the spudger tool to push up on the black clip to free it.

Pull the clip out.

Step 7

  • Lift fur up to reveal the next set of clips.
  • Insert a spudger to push up on the black clip to free it.
  • Pull out the clip.

Lift fur up to reveal the next set of clips.

Insert a spudger to push up on the black clip to free it.

Pull out the clip.

Step 8

  • Lift the fur up and over the Hatchimals Head.
  • Remove the six 12mm Phillips #00 screws from then body.

Lift the fur up and over the Hatchimals Head.

Remove the six 12mm Phillips #00 screws from then body.

Step 9

  • Pull the casing apart.
  • Remove the yellow speaker cable.

Pull the casing apart.

Remove the yellow speaker cable.

Step 10

  • Remove the three 7mm Phillips #00 screws from the head.
  • Remove the wheel base and the circuit board carefully not to damage the spring.

Remove the three 7mm Phillips #00 screws from the head.

Remove the wheel base and the circuit board carefully not to damage the spring.

Step 11

  • Push the six black fur clips out using the spudger.
  • Remove the fur completely.

Push the six black fur clips out using the spudger.

Remove the fur completely.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Kimberly Searles

Member since: 02/14/2018

340 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team S1-G5, Nance Spring 2018                        

                                                  Member of USF Tampa, Team S1-G5, Nance Spring 2018 



                    USFT-NANCE-S18S1G5                     


                                            3 Members                     


                                            5 Guides authored