Difficulty
Moderate
Steps
5
Time Required
25 minutes
Sections
2
- Speaker
- 1 step
- Battery
- 4 steps
Flags
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
BackSprout Channel Cubby
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Dissasemble the device
- Use an opening tool to push in and release sixteen small plastic clips around the edge of the case. As the clips are released, gradually pry the case apart.
- It is easiest to start on the corners.
Use an opening tool to push in and release sixteen small plastic clips around the edge of the case. As the clips are released, gradually pry the case apart.
It is easiest to start on the corners.
1024
Step 2
Battery
- Remove the black electrical tape over the ribbon connector.
- Remove the ribbon connector over the battery.
- Make sure to be careful of the ribbon connector while working on the device.
Remove the black electrical tape over the ribbon connector.
Remove the ribbon connector over the battery.
Make sure to be careful of the ribbon connector while working on the device.
Step 3
- Next you must heat up the battery to help weaken the adhesive connecting the battery to the device.
Next you must heat up the battery to help weaken the adhesive connecting the battery to the device.
Step 4
- Once this is done start to pry the battery away from the device carefully. It helps to start at the corners and move inward.
Once this is done start to pry the battery away from the device carefully. It helps to start at the corners and move inward.
Step 5
- Once you remove the battery from the device it is still connected by three wires: red, black, and, white. It is important to remember the order they are in when reconnecting the new battery.
Once you remove the battery from the device it is still connected by three wires: red, black, and, white. It is important to remember the order they are in when reconnecting the new battery.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 4 other contributors
jasen biggins
Member since: 08/26/2015
735 Reputation
5 Guides authored
Badges:
16
+13 more badges
Team
USF Tampa, Team 14-101, Meier Fall 2015
Member of USF Tampa, Team 14-101, Meier Fall 2015
USFT-MEIER-F15S14G101
4 Members
12 Guides authored
Rachel - Jun 14, 2016
Reply
Ours is only 6 months old. It only works when it stays plugged in. Battery is bad?
larrywb135 - Aug 11, 2016
I had the same problem, only played while plugged in and would not charge.. I found that the battery wires while appearing tight one wire had broken inside the wire insulation at the solder pad on the main board. When I redid the connection it charges, and works well. 8/11/16
jacksondebo2010 - Oct 15, 2017
Reply
My grand daughters won’t come on, should I take it to an electronic store?. I don’t want to try and pry it open, for fear I may make it worse, she loves her tablet, and it is very helpful for her with school, she’s had it 2 years and I put it away for about 8 month, for going on line, without permission, I gave it back in Sept. Now its not charging or coming on. Thank you.Deborah
crzyinind - Dec 28, 2018
Reply
Where can I get a battery?
Liu Woods - Feb 3, 2019