Difficulty
Moderate
Steps
4
Time Required
Suggest a time??
Sections
2
- Outer Case
- 2 steps
- Hand Strap
- 2 steps
Flags
0
BackSun King Solo Solar Lantern
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Locate and Remove the Screws
- Place the lamp LED side down on a clean workspace.
- Remove the screws holding the casing together using a Phillips #1 Screwdriver.
Place the lamp LED side down on a clean workspace.
Remove the screws holding the casing together using a Phillips #1 Screwdriver.
1024
Step 2
Separate the Device
- Gently pull the two halves of the lamp apart.
Gently pull the two halves of the lamp apart.
Step 3
Remove Strap
- Remove both ends of the strap from the orange casing by pulling up.
Remove both ends of the strap from the orange casing by pulling up.
Step 4
Replace the Strap
- Insert the ends of the new strap into the strap housing on both sides of the orange component.
- Either strap housing (inner or outer) can be used to adjust the strap length.
Insert the ends of the new strap into the strap housing on both sides of the orange component.
Either strap housing (inner or outer) can be used to adjust the strap length.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Anna
Member since: 10/23/2014
595 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
Michigan Tech, Team 1-3, Lauer Fall 2014
Member of Michigan Tech, Team 1-3, Lauer Fall 2014
MTU-LAUER-F14S1G3
3 Members
5 Guides authored