Difficulty
Moderate
Steps
8
Time Required
15 - 20 minutes
Sections
3
- Back Cover
- 3 steps
- Battery
- 2 steps
- Rear Facing Camera
- 3 steps
Flags
0
BackSuperSonic Matrix Mid SC-999
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Wedge the plastic opening tool between the back cover of the device and the front panel.
- You will hear a snapping sound as the cover is separated from the body of the device.
Wedge the plastic opening tool between the back cover of the device and the front panel.
You will hear a snapping sound as the cover is separated from the body of the device.
1024
Step 2
- Slide the opening tool along the seam between the front panel and the back cover to un-clip the remaining connections around the device.
- Again, you will hear a snapping sound as the cover is separated from the body of the device.
Slide the opening tool along the seam between the front panel and the back cover to un-clip the remaining connections around the device.
Again, you will hear a snapping sound as the cover is separated from the body of the device.
Step 3
- Lift the back cover from the body of the device to expose the internal components.
Lift the back cover from the body of the device to expose the internal components.
Step 4
Battery
- Remove the Battery
- The battery is secured to the back panel with tape and glue.
- Peel back the tape around the battery and discard it.
- Tear through the adhesive holding the battery by using the spudger tool.
Remove the Battery
The battery is secured to the back panel with tape and glue.
Peel back the tape around the battery and discard it.
Tear through the adhesive holding the battery by using the spudger tool.
Step 5
- Desolder the 2 Battery Wires
- The Battery has two wires connected to the motherboard (one black and one red).
- If you’re unfamiliar with soldering or desoldering check out this guide.
- Be sure to wear protective eye wear. The soldering iron will become extremely hot and a potential danger, so make sure you are aware of your surroundings.
Desolder the 2 Battery Wires
The Battery has two wires connected to the motherboard (one black and one red).
If you’re unfamiliar with soldering or desoldering check out this guide.
Be sure to wear protective eye wear. The soldering iron will become extremely hot and a potential danger, so make sure you are aware of your surroundings.
Step 6
Rear Facing Camera
- Remove the two Phillips #00 screws attaching the housing of the camera to the device.
Remove the two Phillips #00 screws attaching the housing of the camera to the device.
Step 7
- With the screws removed you should easily be able to remove the camera unit.
With the screws removed you should easily be able to remove the camera unit.
Step 8
- Follow the camera unit back to the motherboard.
- Use the spudger tool to remove the camera.
Follow the camera unit back to the motherboard.
Use the spudger tool to remove the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Harris Dagha
Member since: 03/26/2015
866 Reputation
7 Guides authored
Badges:
15
+12 more badges
Team
Dr Shaverz boyz
Member of Dr Shaverz boyz
Community
3 Members
14 Guides authored
