Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

2

  • Case
  • 3 steps
  • Motion Sensor
  • 3 steps

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackSwann Wi-Fi Indoor Security Camera

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

This guide requires the use of a soldering iron, proper safety and usage are advised to avoid injury. In addition, this repair guide requires the handling of electrical components that may be sensitive to ESD (Electrostatic Discharge), so proper ESD protection is also advised.

What you need

Step 1

              Case
  • Use the Phillips #0 to remove the screw located on the back of the camera above the mount.
  • Slide the mount out from the bottom of the device.

Use the Phillips #0 to remove the screw located on the back of the camera above the mount.

Slide the mount out from the bottom of the device.

1024

Step 2

  • Remove the back of the case by placing a iFixit opening tool underneath the edge of the case and prying it up.

Remove the back of the case by placing a iFixit opening tool underneath the edge of the case and prying it up.

Step 3

  • Carefully remove the back of the case without pulling the cables connected to the motherboard and the speaker on the back of the case.

Carefully remove the back of the case without pulling the cables connected to the motherboard and the speaker on the back of the case.

Step 4

              Motion Sensor
  • Facing the inside of the front of the case, release the white ribbon cable by pulling the black rectangular connector at the end of the connection
  • Once the black holder is opened, gently pull the cable out of the holder.

Facing the inside of the front of the case, release the white ribbon cable by pulling the black rectangular connector at the end of the connection

Once the black holder is opened, gently pull the cable out of the holder.

Step 5

  • Facing the back of the small board, remove the two 2.0 mm Phillips #0 black screws that connect it to the back of the case.

Facing the back of the small board, remove the two 2.0 mm Phillips #0 black screws that connect it to the back of the case.

Step 6

  • Carefully use a soldering iron to melt the solder in three places that connect the motion sensor. For more information on soldering follow this helpful guide.
  • Pull the sensor out from the motherboard.

Carefully use a soldering iron to melt the solder in three places that connect the motion sensor. For more information on soldering follow this helpful guide.

Pull the sensor out from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Logan Sluder

Member since: 09/18/2019

544 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Western Carolina University, Team S1-G4, Virtue Fall 2019                        

                                                  Member of Western Carolina University, Team S1-G4, Virtue Fall 2019 



                    WCU-VIRTUE-F19S1G4                     


                                            4 Members                     


                                            12 Guides authored