Difficulty

Moderate

Steps

5

Time Required

                          15 - 40 minutes

Sections

1

  • Camera
  • 5 steps

Flags

0

  • BackTagital T10

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera
  • Always make sure your device is completely powered off before performing repairs.
  • Remove the two 4 mm Phillips head screws at the top of the device.

Always make sure your device is completely powered off before performing repairs.

Remove the two 4 mm Phillips head screws at the top of the device.

1024

Step 2

  • Carefully remove the back cover by using a plastic opening tool, moving all the way around the perimeter of the tablet.
  • Set the back cover aside.
  • The speakers are attached to the inside back cover, and are connected by wires to the motherboard of the tablet. Be careful not to rip these free when removing the back.

Carefully remove the back cover by using a plastic opening tool, moving all the way around the perimeter of the tablet.

Set the back cover aside.

The speakers are attached to the inside back cover, and are connected by wires to the motherboard of the tablet. Be careful not to rip these free when removing the back.

Step 3

  • Pull the black tape away so that the rear-facing camera is no longer attached to the device.

Pull the black tape away so that the rear-facing camera is no longer attached to the device.

Step 4

  • Pull off the plastic camera cover with the tweezers so that the front-facing camera can move freely.

Pull off the plastic camera cover with the tweezers so that the front-facing camera can move freely.

Step 5

  • Locate the small ZIF connector that connects to the cameras.
  • Use the plastic prying tool to pull up the black tab, so that the filament is released. Carefully pull the filament out so it is moving freely.
  • The camera can now be lifted from the device.

Locate the small ZIF connector that connects to the cameras.

Use the plastic prying tool to pull up the black tab, so that the filament is released. Carefully pull the filament out so it is moving freely.

The camera can now be lifted from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Destin Dawsy

Member since: 09/26/2016

328 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 14-5, Eyestone Fall 2016                        

                                                  Member of USF Tampa, Team 14-5, Eyestone Fall 2016 



                    USFT-EYESTONE-F16S14G5                     


                                            4 Members                     


                                            10 Guides authored