Difficulty

Difficult

Steps

6

Time Required

                          20 - 45 minutes

Sections

2

  • Case
  • 1 step
  • Speaker
  • 5 steps

Flags

0

  • BackTagital T7X

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • Place the Tagital T7X on a sturdy surface.
  • Insert the plastic opening tool into the crack and pry open the tablet. Move the tool along the edge, while continuing to pry up the casing.

Place the Tagital T7X on a sturdy surface.

Insert the plastic opening tool into the crack and pry open the tablet. Move the tool along the edge, while continuing to pry up the casing.

1024

Step 2

              Speaker
  • Remove the ribbon cable on the top left corner of the mother board.
  • Gently lift the black tape up to see the ribbon cable socket.

Remove the ribbon cable on the top left corner of the mother board.

Gently lift the black tape up to see the ribbon cable socket.

Step 3

  • Push both side buttons away from the socket by using a spudger.

Push both side buttons away from the socket by using a spudger.

Step 4

  • Gently pull the ribbon cable away from the socket.
  • Don’t be afraid to use some force for this step.

Gently pull the ribbon cable away from the socket.

Don’t be afraid to use some force for this step.

Step 5

  • The soldering iron can destroy components on the motherboard. Only touch the soldering iron to the solder already on the board.
  • Touch the tip of the soldering iron to the solder connecting the positive (red) wire.
  • Pull back on the wire with the iron in place, removing it from the hot solder.
  • Repeat this step for the negative wire.
  • The solder will be melted almost instantly. There is no need to hold the iron on the solder for than a second or two. Visit IFixit’s soldering guide for more info.

The soldering iron can destroy components on the motherboard. Only touch the soldering iron to the solder already on the board.

Touch the tip of the soldering iron to the solder connecting the positive (red) wire.

Pull back on the wire with the iron in place, removing it from the hot solder.

Repeat this step for the negative wire.

The solder will be melted almost instantly. There is no need to hold the iron on the solder for than a second or two. Visit IFixit’s soldering guide for more info.

Step 6

  • Remove the speaker from the motherboard.

Remove the speaker from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Hanlong Chen

Member since: 02/10/2016

265 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 2-1, Sullivan Spring 2016                        

                                                  Member of USF Tampa, Team 2-1, Sullivan Spring 2016 



                    USFT-SULLIVAN-S16S2G1                     


                                            4 Members                     


                                            12 Guides authored