Difficulty

Moderate

Steps

11

Time Required

Suggest a time??

Sections

1

  • Light Element
  • 11 steps

Flags

0

  • BackTatung TAC-6G

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Light Element
  • Start with the device standing upright.

Start with the device standing upright.

1024

Step 2

  • Remove the 11mm Phillips screw from below the power component panel.

Remove the 11mm Phillips screw from below the power component panel.

Step 3

  • Pull the panel away from the rice cooker.
  • Remove the 9mm Phillips screw from behind the power component dashboard that is connected to the light plate.

Pull the panel away from the rice cooker.

Remove the 9mm Phillips screw from behind the power component dashboard that is connected to the light plate.

Step 4

  • Pull the light plate from the power component panel.

Pull the light plate from the power component panel.

Step 5

  • Flip the rice cooker device upside down.

Flip the rice cooker device upside down.

Step 6

  • Remove the one 7mm Phillips screw from the side of the brass panel
  • Lift the brass plate off of the device and set it aside.

Remove the one 7mm Phillips screw from the side of the brass panel

Lift the brass plate off of the device and set it aside.

Step 7

  • Remove the 7mm Phillips screw holding the white and maroon colored wires that are connected to the heating element.

Remove the 7mm Phillips screw holding the white and maroon colored wires that are connected to the heating element.

Step 8

  • Remove the 10mm Phillips screw that connects the white, blue and black wires to the white plastic piece in the corner of the device.

Remove the 10mm Phillips screw that connects the white, blue and black wires to the white plastic piece in the corner of the device.

Step 9

  • Remove the 7mm Phillips screw that connects two white wires and one red wire to the heating “warm” switch.

Remove the 7mm Phillips screw that connects two white wires and one red wire to the heating “warm” switch.

Step 10

  • Using your hand, pull out the light plate with the maroon red and black wires.

Using your hand, pull out the light plate with the maroon red and black wires.

Step 11

  • Replace the light plate dashboard.

Replace the light plate dashboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Erin Charles

Member since: 01/28/2016

215 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of Alabama, Team 1-6, Sydow campbell Spring 2016                        

                                                  Member of University of Alabama, Team 1-6, Sydow campbell Spring 2016 



                    UA-SYDOW CAMPBELL-S16S1G6                     


                                            4 Members                     


                                            3 Guides authored

Tom Anderson - Oct 26, 2022

Reply

Reverse the steps for reassembly.