The TDK Life on Record A26 is a compact, waterproof portable speaker with Bluetooth and speakerphone capabilities.
Student-Contributed Wiki
An awesome team of students from our education program made this wiki.
No matter what you do, you can’t get your speaker to turn on and the on light doesn’t light up.
If the battery is drained then the speaker will not turn on. Make sure to charge the battery fully using the provided charging cable. If the battery is not charging even when plugged in, look at the Failing to Charge section.
Check to see if the on/off switch, located on the side of the speaker near the charging port and the aux cable port, is fully pressed to the on position. Also make sure to press the on/off button on the top of the speaker down firmly until it clicks and hold down for a few seconds until light comes on.
Make sure the volume level is turned up to an audible (where you can hear sound coming from the speaker) level.
The front faceplate with the TDK logo comes off
Press the faceplate back on to the speaker firmly, making sure the logo is upright and not upside down.
The battery is not charging when plugged in and the red charging light does not turn on
Make sure the charger is fully pressed in on both sides and the red charging light (power button) turns on.
Make sure that the charger that is being used is the correct one and not one that looks similar to the real charging cable.
Some charging cables might be defective, therefore, make sure that the charger is fully operational. If everything is plugged in correctly and the charging light still does not turn on, then the charger might be defective. Try buying a new charging cable and recycle the old charger properly.
If the battery is failing to hold a charge, won’t play without being plugged in, and/or drains really fast, the battery might be defective. If it is, go to the Battery Replacement Guide to learn how to replace the speaker’s battery.
The sounds from the speaker are muffled or distorted
If the sounds coming from the speaker sound muffled, then there might be dust clogging the faceplate of the speaker. Remove the faceplate by either prying it off or using a decent magnet to remove it. Brush the dust out of the faceplate using a small brush.
If the speaker sound is distorted, then the speaker cone might be blown out. This can’t be repaired for a permanent fix so recycle it properly.
There is a popping sound when the speaker is turned on
If there is a popping sound, then the volume level might be too high. Turn down the volume to a lower level.
If there is a popping sound coming from the speaker, other electronics might be interfering with the speaker. Remove them from the vicinity. Examples of electronics that could affect the speaker are cell phones (especially older models), radios, walkie talkies, etc.
