Teenage Engineering Op Z Expansion Module Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          20 - 40 seconds

Sections

Back Cover
3 steps
Expansion Module
2 steps

Flags

BackTeenage Engineering OP-Z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Step 1

              Back Cover

Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.
There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

1024

Step 2

When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).
If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

Step 3

Remove the bottom plate including the rubber feet.

Remove the bottom plate including the rubber feet.

Step 4

              Expansion Module

Use your finger or a spudger to push up on the small tab on the bottom of the module.
Lift the module up and out of its recess bottom first.

Use your finger or a spudger to push up on the small tab on the bottom of the module.

Lift the module up and out of its recess bottom first.

Step 5

Remove the module.
When inserting another module make sure you put it in outputs first. Then push down the bottom part for the tab to engage.

Remove the module.

When inserting another module make sure you put it in outputs first. Then push down the bottom part for the tab to engage.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Tobias Isakeit

Member since: 03/31/2014

105,397 Reputation

                                      184 Guides authored                  



                       Badges:
                       46







                                                        +43 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored

Introduction#

Team#

Introduction

Team