Difficulty
Moderate
Steps
10
Time Required
20 - 40 minutes
Sections
2
- Top Cover
- 7 steps
- Case
- 3 steps
Flags
0
BackThe Claw
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Top Cover
- Place The Claw machine in the up-right position with the control knobs facing you.
Place The Claw machine in the up-right position with the control knobs facing you.
1024
Step 2
- Turn The Claw machine upside-down placing the top cover on the surface of your work area.
Turn The Claw machine upside-down placing the top cover on the surface of your work area.
Step 3
- Remove all ten 6mm phillips #1 screws underneath the top cover using your #1 phillips head screwdriver.
- It is helpful to choose a clear, well lit work space. There are multiple tiny screws that are easy to lose.
Remove all ten 6mm phillips #1 screws underneath the top cover using your #1 phillips head screwdriver.
It is helpful to choose a clear, well lit work space. There are multiple tiny screws that are easy to lose.
Step 4
- Turn The Claw machine back to the upright position with controls facing you.
Turn The Claw machine back to the upright position with controls facing you.
Step 5
- Remove the top cover of The Claw machine.
Remove the top cover of The Claw machine.
Step 6
- Remove the ten 6 mm phillips #1 screws from the top flange.
Remove the ten 6 mm phillips #1 screws from the top flange.
Step 7
- Lift the flange upward and off to the side of the machine.
- There is enough wire connecting the flange to the machine that you will not need to cut the wire. The flange can be moved off to the side of the machine while you are working.
- Cutting or ripping out the wire will cause damage to the machine so try not to put much tension on the wire.
Lift the flange upward and off to the side of the machine.
There is enough wire connecting the flange to the machine that you will not need to cut the wire. The flange can be moved off to the side of the machine while you are working.
Cutting or ripping out the wire will cause damage to the machine so try not to put much tension on the wire.
Step 8
Case
- The glass you intend to replace will have four 6mm #1 phillips head screws on either side located in the silver corner pieces.
The glass you intend to replace will have four 6mm #1 phillips head screws on either side located in the silver corner pieces.
Step 9
- Loosen all eight screws using your phillips head #1 screwdriver so that the glass can be removed.
Loosen all eight screws using your phillips head #1 screwdriver so that the glass can be removed.
Step 10
- Gently remove the broken clear plastic case.
- Remember how the case sat into the frame so that you can seat the new case in the same way.
Gently remove the broken clear plastic case.
Remember how the case sat into the frame so that you can seat the new case in the same way.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Alain Pierre
Member since: 03/22/2016
1,149 Reputation
9 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 4-8, Catania Spring 2016
Member of UMass Dartmouth, Team 4-8, Catania Spring 2016
UMASSD-CATANIA-S16S4G8
3 Members
9 Guides authored
cristian2002 - Dec 26, 2018
Reply
where can i get the clear plastic panels
