Thustmaster Ferrari 458 Spider Racing Wheel Usb Cable Replacement Repair Guide

Difficulty

Difficult

Steps

4

Time Required

                          35 minutes            

Sections

2

• Bottom Cover
• 2 steps
• USB Cable Replacement
• 2 steps

Flags

0

• BackThrustmaster Ferrari 458 Spider Racing Wheel

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

What you need

Step 1

              Bottom Cover               

• Remove the black 10mm using a JIS #1 screw driver.
• There are 12 screws.
• Two of the screws are deep inside the device you might need to use a slim screwdriver.
• In the picture you see a plastic opening tool instead of screw driver because we did not have our screw driver when we were taking the picture.

Remove the black 10mm using a JIS #1 screw driver.

There are 12 screws.

Two of the screws are deep inside the device you might need to use a slim screwdriver.

In the picture you see a plastic opening tool instead of screw driver because we did not have our screw driver when we were taking the picture.

1024

Step 2

• Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.
• Gently pull apart both halves of device to access inside.

Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.

Gently pull apart both halves of device to access inside.

Step 3

              USB Cable Replacement               

• Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.

Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.

Step 4

• Desolder the black cable that connects the USB port to the motherboard.
• For more information on how to solder and desolder connections, please visit this guide.

Desolder the black cable that connects the USB port to the motherboard.

For more information on how to solder and desolder connections, please visit this guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Mario Nunez                     

Member since: 10/18/2017

403 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       USF Tampa, Team S1-G33, Cagle Fall 2017                        

                                                  Member of USF Tampa, Team S1-G33, Cagle Fall 2017 



                    USFT-CAGLE-F17S1G33                     


                                            4 Members                     


                                            5 Guides authored                     

Rene Haeren - Sep 7, 2019

Reply

kunt u mij vertellen waar ik het kabeltje kan kopen?

Rene

Malcolm Clenton - Apr 24, 2021

Reply

Can you advise on where to obtain a new usb cable please? (clentonmalcolm@gmail.com)

sunned - May 2, 2021

Have you solved it? I’m worried it’s different from the regular usb line.

lilybaxter505 - May 31, 2022

Reply

Then wat where do u get usb cord to replace it some one plz explian

Hez van der Meij - Sep 28, 2022