Difficulty

Moderate

Steps

7

Time Required

                          20 minutes

Sections

2

  • Case
  • 3 steps
  • Hard Drive
  • 4 steps

Flags

0

  • BackTiVo Premiere XL4

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • Power down the TiVo Premiere XL4 by detaching the power cable from the unit and power source.
  • Allow the box to cool for at least 5 minutes before proceeding to the next step.

Power down the TiVo Premiere XL4 by detaching the power cable from the unit and power source.

Allow the box to cool for at least 5 minutes before proceeding to the next step.

1024

Step 2

  • Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver.

Remove the four 80 mm T10 screws from the back of the TiVo box using theTorx screwdriver.

Step 3

  • Take the outer casing by sliding the top of the box off of the component carefully, making sure not to damage the surrounding components inside.

Take the outer casing by sliding the top of the box off of the component carefully, making sure not to damage the surrounding components inside.

Step 4

              Hard Drive
  • Pinch the connector of the bundle of wires (the bundle having black, red, black and yellow wires) and gently remove from the motherboard.
  • Pinch the connector of the single flat wire and gently remove from motherboard.

Pinch the connector of the bundle of wires (the bundle having black, red, black and yellow wires) and gently remove from the motherboard.

Pinch the connector of the single flat wire and gently remove from motherboard.

Step 5

  • Unscrew the following two 80 mm T10 screws connecting the hard drive to the bottom of the box using the Torx screwdriver.
  • Repeat on the other side of the hard drive.
  • There will be a total of four 80 mm T10 screws removed.

Unscrew the following two 80 mm T10 screws connecting the hard drive to the bottom of the box using the Torx screwdriver.

Repeat on the other side of the hard drive.

There will be a total of four 80 mm T10 screws removed.

Step 6

  • Remove hard drive from box.

Remove hard drive from box.

Step 7

  • Remove the marked (2) T10 screws and washers using a Torx Screwdriver.
  • Repeat on the opposite side for (2) T10 screws.
  • Remove the connecting cable.
  • Keep the fasteners if the hard drive needs to be replaced.

Remove the marked (2) T10 screws and washers using a Torx Screwdriver.

Repeat on the opposite side for (2) T10 screws.

Remove the connecting cable.

Keep the fasteners if the hard drive needs to be replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Frances Prewitt

Member since: 10/22/2018

661 Reputation

                                      6 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Baylor, Team S1-G1, Williams Fall 2018                        

                                                  Member of Baylor, Team S1-G1, Williams Fall 2018 



                    BU-WILLIAMS-F18S1G1                     


                                            3 Members                     


                                            6 Guides authored