Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
2
- Cover
- 3 steps
- Power Supply
- 5 steps
Flags
0
BackTiVo Series 2 TCD24008A
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Cover
- Unscrew the five 0.31 inch T-9 screws on the back cover.
Unscrew the five 0.31 inch T-9 screws on the back cover.
1024
Step 2
- Slide the cover towards the back until it is no longer under the front cover.
Slide the cover towards the back until it is no longer under the front cover.
Step 3
- Lift the cover up and off the device.
Lift the cover up and off the device.
Step 4
Power Supply
- Locate the power supply.
Locate the power supply.
Step 5
- Remove the belt connecting the power supply to the motherboard by pulling it out.
Remove the belt connecting the power supply to the motherboard by pulling it out.
Step 6
- Remove the red, yellow, and black cable connecting the power supply to the hard drive.
Remove the red, yellow, and black cable connecting the power supply to the hard drive.
Step 7
- Remove the two 0.31 inch T-9 screws from the power supply.
Remove the two 0.31 inch T-9 screws from the power supply.
Step 8
- Pinch the plastic plugs and lift the power supply up to detach from plugs.
- All 4 plugs must be detached to remove power supply.
Pinch the plastic plugs and lift the power supply up to detach from plugs.
All 4 plugs must be detached to remove power supply.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Phil Jones
Member since: 10/11/2011
41 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 5-33, Amido Fall 2011
Member of Cal Poly, Team 5-33, Amido Fall 2011
CPSU-AMIDO-F11S5G33
4 Members
7 Guides authored
