Difficulty

Moderate

Steps

9

Time Required

                          10 - 30 minutes

Sections

3

  • Toro Cement Mixer 68009HD 2018 Safety Precautions
  • 5 steps
  • Engine Plate
  • 2 steps
  • V-Belt
  • 2 steps

Flags

0

  • BackToro Cement Mixer 68009HD (2018)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Safety precautions
  • Before you begin, press the engine-stop switch to turn off the engine.

Before you begin, press the engine-stop switch to turn off the engine.

1024

Step 2

  • Unlatch the three rubber straps securing the cowl.

Unlatch the three rubber straps securing the cowl.

Step 3

  • Swing the cowl up until it rests securely on the frame.

Swing the cowl up until it rests securely on the frame.

Step 4

  • Slide the fuel cutoff lever to the left to cut the fuel supply to the engine.

Slide the fuel cutoff lever to the left to cut the fuel supply to the engine.

Step 5

  • Grab the plastic housing at the end of the spark plug wire.
  • Pull firmly to disconnect the wire from the spark plug.

Grab the plastic housing at the end of the spark plug wire.

Pull firmly to disconnect the wire from the spark plug.

Step 6

              Remove the engine plate
  • Remove the four fasteners securing the engine plate:
  • Two 14 mm bolts
  • Two 3/4 inch nuts

Remove the four fasteners securing the engine plate:

Two 14 mm bolts

Two 3/4 inch nuts

Step 7

  • Slide the engine plate up and out of the device to remove it.

Slide the engine plate up and out of the device to remove it.

Step 8

              Remove the V-belts
  • Use a 3/4 inch wrench to loosen the four bolts securing the engine to the frame.
  • You don’t need to fully remove these bolts—loosen them enough to create slack in order to remove and replace the belts.

Use a 3/4 inch wrench to loosen the four bolts securing the engine to the frame.

You don’t need to fully remove these bolts—loosen them enough to create slack in order to remove and replace the belts.

Step 9

  • If you are replacing the belts, you can choose to cut the old ones to remove them.
  • Slide the belts off from the pulleys and remove them.
  • If you have trouble sliding the belts off, further loosen the four engine bolts to create more slack.

If you are replacing the belts, you can choose to cut the old ones to remove them.

Slide the belts off from the pulleys and remove them.

If you have trouble sliding the belts off, further loosen the four engine bolts to create more slack.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Arthur Shi

Member since: 01/03/2018

211,874 Reputation

                                      442 Guides authored                  



                       Badges:
                       46







                                                        +43 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored