Difficulty
Moderate
Steps
12
Time Required
15 minutes
Sections
1
- DVD Drive
- 12 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackToshiba Portable DVD Player SD-P1700
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
DVD Drive
- Turn the DVD player upside down.
- Slide the lock switch to the side.
- Slide the battery pack toward the lock switch and off of the back case.
Turn the DVD player upside down.
Slide the lock switch to the side.
Slide the battery pack toward the lock switch and off of the back case.
1024
Step 2
- Remove the following twelve screws:
- Ten 7 mm Phillips #00 screws
- Two 8 mm Phillips #00 screws
Remove the following twelve screws:
Ten 7 mm Phillips #00 screws
Two 8 mm Phillips #00 screws
Step 3
- Use your fingers to pull the back case away from the body of the DVD player.
- Remove the back case.
Use your fingers to pull the back case away from the body of the DVD player.
Remove the back case.
Step 4
- Use your fingers to pull off the plastic sheet.
Use your fingers to pull off the plastic sheet.
Step 5
- Remove the following screw:
- One 2 mm Phillips #00 screw
- Detach the gray wire.
Remove the following screw:
One 2 mm Phillips #00 screw
Detach the gray wire.
Step 6
- Disconnect the ribbon cable by pulling it straight out of the connector.
Disconnect the ribbon cable by pulling it straight out of the connector.
Step 7
- Remove the following five screws:
- Three 4 mm Phillips #00 screws
- Two 2 mm Phillips #00 screws
Remove the following five screws:
Three 4 mm Phillips #00 screws
Two 2 mm Phillips #00 screws
Step 8
- Remove three rubber stoppers.
Remove three rubber stoppers.
Step 9
- Remove the following screws:
- Two 4mm Phillips #00 screws
Remove the following screws:
Two 4mm Phillips #00 screws
Step 10
- Use your fingers to pry the motherboard away from the upper case so you can access the DVD drive wires.
Use your fingers to pry the motherboard away from the upper case so you can access the DVD drive wires.
Step 11
- Flip the DVD player over to access the drive wires.
- Pull the bundled cable away from the connector in the same direction the individual wires are running.
Flip the DVD player over to access the drive wires.
Pull the bundled cable away from the connector in the same direction the individual wires are running.
Step 12
- Remove all of the DVD drive components from the case.
Remove all of the DVD drive components from the case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Katarina Howald
Member since: 03/18/2020
205 Reputation
1 Guide authored
Badges:
2
