Difficulty

Easy

Steps

6

Time Required

                          1 - 4 minutes

Sections

2

  • Battery
  • 3 steps
  • Hard Drive
  • 3 steps

Flags

0

  • BackToshiba Satellite A660-ST3NX2X

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Unplug all cables and other devices from the computer before starting this replacement.
  • Turn the computer over, so the screen is facing down and the battery is positioned in front of you.

Unplug all cables and other devices from the computer before starting this replacement.

Turn the computer over, so the screen is facing down and the battery is positioned in front of you.

1024

Step 2

  • Locate the two sliding tabs on either side of the battery.
  • Using both hands, place one finger on each tab and slide them to the sides and away from each other.

Locate the two sliding tabs on either side of the battery.

Using both hands, place one finger on each tab and slide them to the sides and away from each other.

Step 3

  • Pull the battery out, keeping the tabs pushed to the side.
  • The right tab on this laptop stayed pushed to the right without needing to be held in place.

Pull the battery out, keeping the tabs pushed to the side.

The right tab on this laptop stayed pushed to the right without needing to be held in place.

Step 4

              Hard Drive
  • Unplug all devices from your computer and power down the device completely.
  • Flip the computer over so the screen is facing down.
  • In the image, the hard drive will appear to be in the top right corner where the box indicates.

Unplug all devices from your computer and power down the device completely.

Flip the computer over so the screen is facing down.

In the image, the hard drive will appear to be in the top right corner where the box indicates.

Step 5

  • Use a J00 bit to unscrew the single 4mm screw that holds the hard drive cover in place.

Use a J00 bit to unscrew the single 4mm screw that holds the hard drive cover in place.

Step 6

  • Remove the cover that holds the hard drive in place.
  • Remove the hard drive.
  • This computer contains no hard drive, therefore we are unable to show the physical removal of it.

Remove the cover that holds the hard drive in place.

Remove the hard drive.

This computer contains no hard drive, therefore we are unable to show the physical removal of it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Cassie Pickett

Member since: 03/20/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       Texas Tech, Team S8-G1, Bennett Spring 2017                        

                                                  Member of Texas Tech, Team S8-G1, Bennett Spring 2017 



                    TTU-BENNETT-S17S8G1                     


                                            4 Members                     


                                            10 Guides authored