Difficulty

Moderate

Steps

8

Time Required

                          7 minutes

Sections

3

  • Battery
  • 2 steps
  • Lower Case
  • 4 steps
  • RAM
  • 2 steps

Flags

0

  • BackToshiba Satellite C50D-A

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Click button 1 to the unlocked position.
  • This button will have a 1 by it.

Click button 1 to the unlocked position.

This button will have a 1 by it.

1024

Step 2

  • Push and hold button 2 to the left.
  • As you push button 2 to the left position, simultaneously lift up the battery pack.
  • This button will have a 2 by it.

Push and hold button 2 to the left.

As you push button 2 to the left position, simultaneously lift up the battery pack.

This button will have a 2 by it.

Step 3

              Lower Case
  • Using the Phillips #1 screwdriver, remove the eleven 2.5mm screws.

Using the Phillips #1 screwdriver, remove the eleven 2.5mm screws.

Step 4

  • Remove the one 2.5mm Phillips #1 middle plate screw.

Remove the one 2.5mm Phillips #1 middle plate screw.

Step 5

  • Lift up the middle vent panel.
  • Set the panel to the side.

Lift up the middle vent panel.

Set the panel to the side.

Step 6

  • Using the plastic opening tool, remove the outer panel and set to the side.
  • Be careful not to break the back of the computer.

Using the plastic opening tool, remove the outer panel and set to the side.

Be careful not to break the back of the computer.

Step 7

              RAM
  • Using your fingers, unclip the two side clips.

Using your fingers, unclip the two side clips.

Step 8

  • The RAM should now be at a 30 degree angle.
  • Using your fingers, unclip the top two clips.
  • The RAM should just pop out. You can remove it with your fingers.
  • This will apply to either top or bottom RAM.

The RAM should now be at a 30 degree angle.

Using your fingers, unclip the top two clips.

The RAM should just pop out. You can remove it with your fingers.

This will apply to either top or bottom RAM.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Amber van Solingen

Member since: 01/29/2018

657 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       University of Alabama, Team S3-G11, Bedsole Spring 2018                        

                                                  Member of University of Alabama, Team S3-G11, Bedsole Spring 2018 



                    UA-BEDSOLE-S18S3G11                     


                                            3 Members                     


                                            12 Guides authored