Difficulty
Moderate
Steps
8
Time Required
15 - 20 minutes
Sections
2
- Battery
- 3 steps
- Screen
- 5 steps
Flags
0
BackToshiba Satellite C55-A5302
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Power down the laptop and remove all power cords. After this is done, turn the laptop over.
Power down the laptop and remove all power cords. After this is done, turn the laptop over.
1024
Step 2
- Slide the battery latches outwards away from the center of the device.
- The right latch will slide to the right, and left latch to the left.
Slide the battery latches outwards away from the center of the device.
The right latch will slide to the right, and left latch to the left.
Step 3
- Lift and remove the battery from the device.
Lift and remove the battery from the device.
Step 4
Screen
- Use tweezers to remove the screw covers in the lower corners of the screen.
Use tweezers to remove the screw covers in the lower corners of the screen.
Step 5
- Use the Phillips #1 screwdriver to unscrew the two screws in the lower corners of the screen.
Use the Phillips #1 screwdriver to unscrew the two screws in the lower corners of the screen.
Step 6
- Start popping off the cover all the way around the screen until it comes off.
Start popping off the cover all the way around the screen until it comes off.
Step 7
- Remove the two screws in the top corners with a Phillips #1 screwdriver. The screen will pop forward after removing the two screws.
- Using the same Phillips #1 screwdriver, remove the three screws on the side of screen frame.
Remove the two screws in the top corners with a Phillips #1 screwdriver. The screen will pop forward after removing the two screws.
Using the same Phillips #1 screwdriver, remove the three screws on the side of screen frame.
Step 8
- On the back of screen, lift up the plastic film and screen connector. Pop out the connector, and gently remove the screen.
On the back of screen, lift up the plastic film and screen connector. Pop out the connector, and gently remove the screen.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Nicole Hague
Member since: 04/10/2018
572 Reputation
4 Guides authored
Badges:
8
+5 more badges
Team
Eastern Washington University, Team S2-G2, Ramos Spring 2018
Member of Eastern Washington University, Team S2-G2, Ramos Spring 2018
EWU-RAMOS-S18S2G2
4 Members
10 Guides authored