Difficulty

Moderate

Steps

9

Time Required

                          10 minutes

Sections

2

  • Battery
  • 6 steps
  • Speaker
  • 3 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackToshiba Satellite CL15t-B1204X

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Flip the laptop over so the bottom of the device is facing upward.

Flip the laptop over so the bottom of the device is facing upward.

1024

Step 2

  • Unscrew the 10 5mm Phillips screws, located on the bottom side of the notebook using the PH1 bit and the Magnetic Driver.

Unscrew the 10 5mm Phillips screws, located on the bottom side of the notebook using the PH1 bit and the Magnetic Driver.

Step 3

  • Pry open the bottom cover of the notebook with the plastic spudger tools. Slide a thin tool along the edges without ports to pop open the latches.
  • Be careful not to bend or crack the plastic back cover.

Pry open the bottom cover of the notebook with the plastic spudger tools. Slide a thin tool along the edges without ports to pop open the latches.

Be careful not to bend or crack the plastic back cover.

Step 4

  • Remove the 1" yellow tape on top of the battery. This piece of tape is holding down the battery connection cable.

Remove the 1" yellow tape on top of the battery. This piece of tape is holding down the battery connection cable.

Step 5

  • Lightly grip the battery on the two longest sides. Gently pull up until the adhesive on the notebook is separated from the battery.

Lightly grip the battery on the two longest sides. Gently pull up until the adhesive on the notebook is separated from the battery.

Step 6

  • Carefully unplug the battery from the device motherboard.

Carefully unplug the battery from the device motherboard.

Step 7

              Speaker
  • Carefully unplug the speaker’s cord from the I/O board.

Carefully unplug the speaker’s cord from the I/O board.

Step 8

  • Unscrew the two 3mm screws with the PH1 screw head on each speaker found on the corner’s away from the hinges.

Unscrew the two 3mm screws with the PH1 screw head on each speaker found on the corner’s away from the hinges.

Step 9

  • Remove the speakers.

Remove the speakers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Royce Alexander Porter

Member since: 09/10/2018

643 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Appalachian State University, Team S2-G3, Menagarishvili Fall 2018                        

                                                  Member of Appalachian State University, Team S2-G3, Menagarishvili Fall 2018 



                    APSU-MENAGARISHVILI-F18S2G3                     


                                            3 Members                     


                                            9 Guides authored