Difficulty
Moderate
Steps
10
Time Required
15 - 25 minutes
Sections
2
- Battery
- 5 steps
- Display
- 5 steps
Flags
0
BackToshiba Satellite P55W-C5200X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Use the Phillips #00 screwdriver to remove the ten 4.0 mm screws located at the bottom of the laptop.
Use the Phillips #00 screwdriver to remove the ten 4.0 mm screws located at the bottom of the laptop.
1024
Step 2
- Use the black nylon spudger to pry the back casing along the edges.
- Continue to pry along the edge of the back case until the back is ready to be removed.
Use the black nylon spudger to pry the back casing along the edges.
Continue to pry along the edge of the back case until the back is ready to be removed.
Step 3
- Remove the four 6.0 mm screws that hold the battery in place using the JIS #000 screwdriver.
Remove the four 6.0 mm screws that hold the battery in place using the JIS #000 screwdriver.
Step 4
- Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.
Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.
Step 5
- Gently remove the battery from your device.
Gently remove the battery from your device.
Step 6
Display
- Use the Phillips #00 screwdriver to remove the six 5.0 mm screws that are holding the metal brackets on both sides in place.
- Gently remove both metal brackets.
Use the Phillips #00 screwdriver to remove the six 5.0 mm screws that are holding the metal brackets on both sides in place.
Gently remove both metal brackets.
Step 7
- Remove he three wires connected to the motherboard.
Remove he three wires connected to the motherboard.
Step 8
- On the other side remove the four remaining wires from their ports.
On the other side remove the four remaining wires from their ports.
Step 9
- Lift two sets of metal brackets up, one in each corner.
- Depending on the force needed on your specific device, you may need to use the spudger.
Lift two sets of metal brackets up, one in each corner.
Depending on the force needed on your specific device, you may need to use the spudger.
Step 10
- Gently lift the device away from the display assembly.
- Be aware of the wires attached to the screen so they don’t snag on anything.
Gently lift the device away from the display assembly.
Be aware of the wires attached to the screen so they don’t snag on anything.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Hadi Termos
Member since: 10/21/2019
238 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team S1-G2, Botvin Fall 2019
Member of UMass Dartmouth, Team S1-G2, Botvin Fall 2019
UMASSD-BOTVIN-F19S1G2
4 Members
10 Guides authored