Difficulty
Easy
Steps
7
Time Required
10 minutes
Sections
1
- RAM
- 7 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackToshiba Satellite S75D-A7346
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Taking Out The Battery
- First we have to take out the battery
- Pull the switch on the left to the left
- then hold the switch on the right to the right direction
- then pull up the bttery from the point inbetween the 2 switches
First we have to take out the battery
Pull the switch on the left to the left
then hold the switch on the right to the right direction
then pull up the bttery from the point inbetween the 2 switches
1024
Step 2
UnScrewing The BackPlate
- Unscrew the screw located next to the information sticker
- Then get a screw driver or prier to gently pry the covering plate
Unscrew the screw located next to the information sticker
Then get a screw driver or prier to gently pry the covering plate
Step 3
Taking Out The RAM Sticks
- Gently move the 2 notches on the ends of each ram stick and the stick should pop out at a 30 degree angle
- then pull that ram stick out
- you can do the same to the other one
Gently move the 2 notches on the ends of each ram stick and the stick should pop out at a 30 degree angle
then pull that ram stick out
you can do the same to the other one
Step 4
Adding In New RAM Sticks
- Insert the lowest ram stick first by inserting it at a 30 degree angle then push down on it
- Note: do not put a lot of pressure on it
- Note: make sure before you push it down the RAM stick is all the way in
- Note: The maximum supported RAM is 8 GB in each slot of DDR3 1600Mhz
Insert the lowest ram stick first by inserting it at a 30 degree angle then push down on it
Note: do not put a lot of pressure on it
Note: make sure before you push it down the RAM stick is all the way in
Note: The maximum supported RAM is 8 GB in each slot of DDR3 1600Mhz
Step 5
Putting On The Backplate
- Put on the backplate and put pressure arround the edges of the blackplate so it stays flat with the case
- Then screw in the screw next to the information sticker
Put on the backplate and put pressure arround the edges of the blackplate so it stays flat with the case
Then screw in the screw next to the information sticker
Step 6
Putting In The Battery
- Place the battery in the slot
- Then hold the right switch to the right and push the battery in, then release the switch.
- move the left switch to the right
Place the battery in the slot
Then hold the right switch to the right and push the battery in, then release the switch.
move the left switch to the right
Step 7
You Finished
- You have know finished the replacement
You have know finished the replacement
Cancel: I did not complete this guide.
Author
with 1 other contributor
Emil Lambert
Member since: 12/16/2016
228 Reputation
2 Guides authored
Badges:
4
+1 more badge