Difficulty
Moderate
Steps
8
Time Required
7 - 10 minutes
Sections
2
- Toshiba Satellite U840W Disassembly Guide
- 5 steps
- 12V Charging Port
- 3 steps
Flags
0
BackToshiba Satellite U840W
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Toshiba Satellite U840W Disassembly Guide
- There are ten 5mm screws surrounding the edge of the cover.
- A rubber cap covers the eleventh 5mm screw (in the center).
- Remove the screws using a Phillips #00 screwdriver.
There are ten 5mm screws surrounding the edge of the cover.
A rubber cap covers the eleventh 5mm screw (in the center).
Remove the screws using a Phillips #00 screwdriver.
1024
Step 2
- Pry between the casing and cover using a plastic wedge tool.
- Use the wedge tool to move along the case & slowly pry it open.
- The wire for the 12v charging port connects the cover to the casing.
Pry between the casing and cover using a plastic wedge tool.
Use the wedge tool to move along the case & slowly pry it open.
The wire for the 12v charging port connects the cover to the casing.
Step 3
- Disconnect this connector from the motherboard to avoid damaging the motherboard or charging port cable.
Disconnect this connector from the motherboard to avoid damaging the motherboard or charging port cable.
Step 4
- Disconnect the battery.
- Hold down the power button for ~10 seconds to discharge any stored electricity from the motherboard.
Disconnect the battery.
Hold down the power button for ~10 seconds to discharge any stored electricity from the motherboard.
Step 5
- At this point you should be able to:
- Replace 12V Charging Port
- Replace RAM
- Replace Processor Fan
- Replace Speakers
At this point you should be able to:
Replace 12V Charging Port
Replace RAM
Replace Processor Fan
Replace Speakers
Step 6
12V Charging Port
- Remove the connector from the motherboard.
- This separates the only connection from the motherboard to the cover.
Remove the connector from the motherboard.
This separates the only connection from the motherboard to the cover.
Step 7
- Remove the screw holding 12v charging port to the cover.
Remove the screw holding 12v charging port to the cover.
Step 8
- Remove the 12v charging port from the cover.
Remove the 12v charging port from the cover.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Joshua Pedersen
Member since: 02/04/2019
217 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
Gateway, Team S1-G1, Saknee Spring 2019
Member of Gateway, Team S1-G1, Saknee Spring 2019
GCC-SAKNEE-S19S1G1
4 Members
5 Guides authored