Toshiba Tecra R940 Hard Drive Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          5 minutes            

Sections

1

• Hard Drive
• 3 steps

Flags

0

• BackToshiba TECRA R840

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Hard Drive               

• Loosen the screw holding the back panel for RAM in place using a Phillips #0 screwdriver. Once loosened, lift the panel up and set it aside.
• The screw holding the panel in place should not come completely out. If it does, do not be alarmed as it will still screw back in.

Loosen the screw holding the back panel for RAM in place using a Phillips #0 screwdriver. Once loosened, lift the panel up and set it aside.

The screw holding the panel in place should not come completely out. If it does, do not be alarmed as it will still screw back in.

1024

Step 2

• Remove the 11mm screw from the right side of the hard drive access panel using a Phillips #0 screwdriver.
• Remove the 3.5 mm screw from the left side of the access panel using a Phillips #0 screwdriver.
• Use a plastic opening tool to pry off the access panel from the bottom.

Remove the 11mm screw from the right side of the hard drive access panel using a Phillips #0 screwdriver.

Remove the 3.5 mm screw from the left side of the access panel using a Phillips #0 screwdriver.

Use a plastic opening tool to pry off the access panel from the bottom.

Step 3

• Gently lift the hard drive from the left side and disconnect the SATA connector from the right side. Completely remove the hard drive.

Gently lift the hard drive from the left side and disconnect the SATA connector from the right side. Completely remove the hard drive.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Holly Strauch                     

Member since: 09/23/2018

409 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Central Washington University, Team S1-G5, Pengilly Fall 2018                        

                                                  Member of Central Washington University, Team S1-G5, Pengilly Fall 2018 



                    CWU-PENGILLY-F18S1G5                     


                                            3 Members                     


                                            14 Guides authored                     

Remy Secor - Dec 9, 2020

Reply

I cannot lift up the “back cover” (step 1). I’ve twirled the screw left for minutes and tried to lift up the panel using a small flathead screwdriver and it will not lift up. HELP!