Trio Stealth G2 Hype Battery Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          3 minutes

Sections

Back Panel
3 steps
Speakers
2 steps
Battery
2 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackTrio Stealth G2 Hype
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Back Panel

Remove the two 1.2 mm Phillips #0 screws found at the side by the power button.

Remove the two 1.2 mm Phillips #0 screws found at the side by the power button.

1024

Step 2

Using the plastic opening tool, insert it between the back panel and screen starting on the corner to the right of the power button side and begin separating the back cover.
Be cautious when opening the back cover as it is connected through fragile wires to the speaker.

Using the plastic opening tool, insert it between the back panel and screen starting on the corner to the right of the power button side and begin separating the back cover.

Be cautious when opening the back cover as it is connected through fragile wires to the speaker.

Step 3

Remove the speakers by using your hand to entirely disconnect the back cover.

Remove the speakers by using your hand to entirely disconnect the back cover.

Step 4

              Speakers

Carefully peel the tape holding down the wires connected to the speaker.

Carefully peel the tape holding down the wires connected to the speaker.

Step 5

In order to replace the speakers after they are removed, you must solder the wires back onto the motherboard.
The red wire must be soldered onto the “+” terminal while the black wire must be terminal must be soldered onto the “-” terminal.
Pull the speaker and wires from the motherboard.

In order to replace the speakers after they are removed, you must solder the wires back onto the motherboard.

The red wire must be soldered onto the “+” terminal while the black wire must be terminal must be soldered onto the “-” terminal.

Pull the speaker and wires from the motherboard.

Step 6

              Battery

While holding the mother board down, slowly remove the battery from tape on the back of the screen.
Make sure to keep all wires attached for now.

While holding the mother board down, slowly remove the battery from tape on the back of the screen.

Make sure to keep all wires attached for now.

Step 7

In order to replace the battery once the wires are removed, you will need to solder the wires of the new battery onto the motherboard.
The red wire must be soldered to the “+” terminal while the black is soldered to the “-” terminal.
Pull the wires off the motherboard.

In order to replace the battery once the wires are removed, you will need to solder the wires of the new battery onto the motherboard.

The red wire must be soldered to the “+” terminal while the black is soldered to the “-” terminal.

Pull the wires off the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor

                    Thomas Lichtenberger

Member since: 01/21/2015

438 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 4-4, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 4-4, Brown Winter 2015 



                    USFT-BROWN-W15S4G4                     


                                            3 Members                     


                                            3 Guides authored

Better Introduction#

What you need#

Team#

Better Introduction

What you need

Team