Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
2
- Propellers
- 1 step
- Drone Cover
- 3 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackUDI U818A
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Propellers
- Remove the 5 mm screws connecting each propeller to the rotating post using a Phillips #000 screwdriver.
- As each screw is removed, safely pull the respective propeller from its apparatus.
Remove the 5 mm screws connecting each propeller to the rotating post using a Phillips #000 screwdriver.
As each screw is removed, safely pull the respective propeller from its apparatus.
1024
Step 2
Drone Cover
- Remove four 3 mm screws connecting the electronics to the frame using a Phillips #000 screwdriver.
- Pull the two LED bars through the dust cover and remove the thin plastic dust cover from the drone.
- As the piece connecting the electronics to the drone cover are accessible, keep note to not remove electronics until after disconnecting the drone head lamp first.
Remove four 3 mm screws connecting the electronics to the frame using a Phillips #000 screwdriver.
Pull the two LED bars through the dust cover and remove the thin plastic dust cover from the drone.
As the piece connecting the electronics to the drone cover are accessible, keep note to not remove electronics until after disconnecting the drone head lamp first.
Step 3
- Remove the single 5 mm screw from the head lamp using a Phillips #000 screwdriver.
- Remove the head lamp from the rest of the drone.
- Disconnect the electronics from the frame of the drone by pulling each arm out of the hole in the frame holding it in place.
- Do not try to separate the frame from the electronics yet! Check to see if there is tape holding the head lamp wires in place underneath the electronics.
Remove the single 5 mm screw from the head lamp using a Phillips #000 screwdriver.
Remove the head lamp from the rest of the drone.
Disconnect the electronics from the frame of the drone by pulling each arm out of the hole in the frame holding it in place.
Do not try to separate the frame from the electronics yet! Check to see if there is tape holding the head lamp wires in place underneath the electronics.
Step 4
- If present, remove the white tape over the black and red wires on the head lamp with a spudger.
- Keep the tape in reusable condition to re-secure the headlight later so there are no loose wires.
- Separate the plastic tabs securing the motor arms to the drone cover and delicately pull out the arm. Do this for all four arms to remove the frame from the cover.
If present, remove the white tape over the black and red wires on the head lamp with a spudger.
Keep the tape in reusable condition to re-secure the headlight later so there are no loose wires.
Separate the plastic tabs securing the motor arms to the drone cover and delicately pull out the arm. Do this for all four arms to remove the frame from the cover.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 9 other contributors
Anthony Mitchell
Member since: 03/23/2016
820 Reputation
5 Guides authored
Badges:
14
+11 more badges
Team
UMass Dartmouth, Team 1-4, Miles Spring 2016
Member of UMass Dartmouth, Team 1-4, Miles Spring 2016
UMASSD-MILES-S16S1G4
3 Members
5 Guides authored
