Difficulty

Difficult

Steps

9

Time Required

                          30 - 45 minutes

Sections

3

  • Battery
  • 3 steps
  • Handset Case
  • 4 steps
  • Circuit Board/Screen
  • 2 steps

Flags

1

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackUniden D1483-3BK

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Set the phone with dial keys facing downward.

Set the phone with dial keys facing downward.

1024

Step 2

  • Slide the battery cover toward the bottom of the phone.
  • Lift and remove the back cover from the phone.

Slide the battery cover toward the bottom of the phone.

Lift and remove the back cover from the phone.

Step 3

  • Remove the battery from its compartment.
  • Pinch the end of cord where the battery is attached to the phone and pull up gently.

Remove the battery from its compartment.

Pinch the end of cord where the battery is attached to the phone and pull up gently.

Step 4

              Handset Case
  • Remove the two 9mm Phillips #1 screws in the battery compartment.

Remove the two 9mm Phillips #1 screws in the battery compartment.

Step 5

  • Use the plastic opening tool to carefully separate the two halves of the case.
  • Slowly work around the entire case to fully separate the halves before pulling them apart.
  • Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.

Use the plastic opening tool to carefully separate the two halves of the case.

Slowly work around the entire case to fully separate the halves before pulling them apart.

Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.

Step 6

  • Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.

Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.

Step 7

  • Carefully grasp either side of the circuit board and lift it straight out of the front half of the case.
  • Set the board in the lower half of the case.

Carefully grasp either side of the circuit board and lift it straight out of the front half of the case.

Set the board in the lower half of the case.

Step 8

              Circuit Board/Screen
  • Set the circuit board on the table with the screen facing down.

Set the circuit board on the table with the screen facing down.

Step 9

  • Using the desoldering braid and soldering iron, remove the solder around the cable for the speaker.
  • When installing the new board, use the soldering iron and solder to reattach the speaker cables.

Using the desoldering braid and soldering iron, remove the solder around the cable for the speaker.

When installing the new board, use the soldering iron and solder to reattach the speaker cables.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.

Author

                                      with 2 other contributors 


                    Arbitrary Name

Member since: 01/28/2015

1,083 Reputation

                                      4 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       Penn State, Team 1-8, Kaschak Winter 2015                        

                                                  Member of Penn State, Team 1-8, Kaschak Winter 2015 



                    PSU-KASCHAK-W15S1G8                     


                                            4 Members                     


                                            8 Guides authored