Difficulty

Moderate

Steps

10

Time Required

                          15 - 25 minutes

Sections

1

  • Speaker Woofer
  • 10 steps

Flags

0

  • BackUrge Basics Soundbrick

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Speaker Woofer
  • Flip the speaker upside down.
  • Unscrew the middle screw with a Philips #1 screwdriver.

Flip the speaker upside down.

Unscrew the middle screw with a Philips #1 screwdriver.

1024

Step 2

  • Peel off the two gray tabs to expose the four inner Philips #1 screws.

Peel off the two gray tabs to expose the four inner Philips #1 screws.

Step 3

  • Unscrew all four screws with a Philips #1 screwdriver.
  • The screws are deep and can be difficult to take out.

Unscrew all four screws with a Philips #1 screwdriver.

The screws are deep and can be difficult to take out.

Step 4

  • Flip the speaker so that the ports are facing up.
  • Unfold the speaker’s cover away from the body.

Flip the speaker so that the ports are facing up.

Unfold the speaker’s cover away from the body.

Step 5

  • Remove the two Phillips #1 screws found on each side of the battery compartment.
  • Removal of battery compartment is necessary to prevent electric shock when replacing the woofer.

Remove the two Phillips #1 screws found on each side of the battery compartment.

Removal of battery compartment is necessary to prevent electric shock when replacing the woofer.

Step 6

  • Disconnect the battery connectors attached to the circuit board by unplugging them.

Disconnect the battery connectors attached to the circuit board by unplugging them.

Step 7

  • Disconnect the ribbon cable from the battery by carefully pulling it out.
  • Remove the battery compartment.

Disconnect the ribbon cable from the battery by carefully pulling it out.

Remove the battery compartment.

Step 8

  • Disconnect the adjacent connector from the main circuit board.

Disconnect the adjacent connector from the main circuit board.

Step 9

  • Disconnect the woofer’s two connectors from the main circuit board.

Disconnect the woofer’s two connectors from the main circuit board.

Step 10

  • Remove the two Phillips #1 screws keeping each woofer in place.
  • Carefully remove the woofers and replace them with new ones.

Remove the two Phillips #1 screws keeping each woofer in place.

Carefully remove the woofers and replace them with new ones.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Itzel Urueta

Member since: 04/28/2017

125 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UC Davis, Team S2-G4, Cole Spring 2017                        

                                                  Member of UC Davis, Team S2-G4, Cole Spring 2017 



                    UCD-COLE-S17S2G4                     


                                            3 Members                     


                                            1 Guide authored