Viasys Avea Exhalation Corner Assembly Removal Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 15 minutes

Sections

Viasys Avea Exhalation Corner Assembly Removal
6 steps

Flags

BackViasys Avea Ventilator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Removing the Exhalation Corner Assembly is discussed in service manual revision D:

Chapter 4: Assembly and Disassembly, Pg 51-52

PLEASE NOTE: This repair guide was developed by a student iFixit team based on Viasys/CareFusion’s own service manual. Neither iFixit nor this repair guide is endorsed by or affiliated with Viasys or CareFusion.

Step 1

              Viasys Avea Exhalation Corner Assembly Removal

Check to see if the exhalation filter assembly is installed, if it is, remove the exhalation filter assembly.
Rotate the metal locking lever on the lower right of the ventilator body forward to an open position.
Remove the exhalation filter assembly from the ventilator body by pulling straight down.

Check to see if the exhalation filter assembly is installed, if it is, remove the exhalation filter assembly.

Rotate the metal locking lever on the lower right of the ventilator body forward to an open position.

Remove the exhalation filter assembly from the ventilator body by pulling straight down.

1024

Step 2

Using a long Phillips screwdriver, remove the Phillips screw located at the top of the exhalation filter assembly well, if applicable.

Using a long Phillips screwdriver, remove the Phillips screw located at the top of the exhalation filter assembly well, if applicable.

Step 3

Using a long Phillips screwdriver, remove the Phillips screw located at the exhalation port marked EXH, if applicable.

Using a long Phillips screwdriver, remove the Phillips screw located at the exhalation port marked EXH, if applicable.

Step 4

Using a long Phillips screwdriver, remove the Phillips screw from the outside of the plastic cover.

Using a long Phillips screwdriver, remove the Phillips screw from the outside of the plastic cover.

Step 5

Using a long Phillips screwdriver, remove the Phillips screw on the font left wall.
Using a long Phillips screwdriver, remove the Phillips screw on the right side of the wall.
Set the plastic cover aside.

Using a long Phillips screwdriver, remove the Phillips screw on the font left wall.

Using a long Phillips screwdriver, remove the Phillips screw on the right side of the wall.

Set the plastic cover aside.

Step 6

Using a long Phillips screwdriver, remove the 3 Phillips screws on the metal re-enforcement cover, if applicable, and set aside.
Remove the Exhalation Corner Assembly.

Using a long Phillips screwdriver, remove the 3 Phillips screws on the metal re-enforcement cover, if applicable, and set aside.

Remove the Exhalation Corner Assembly.

To reassemble your device, follow the steps in the reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Alden Glassey

Member since: 04/19/2018

486 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team S1-G1, Zimmerman Spring 2020                        

                                                  Member of Cal Poly, Team S1-G1, Zimmerman Spring 2020 



                    CPSU-ZIMMERMAN-S20S1G1                     


                                            5 Members                     


                                            6 Guides authored

Introduction#

Team#

Introduction

Team