Visual Land Prestige 7L Front Facing Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

Back Panel
3 steps
Front Facing Camera
2 steps

Flags

BackVisual Land Prestige 7L
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Remove the two 8mm Phillips Head screws located at the bottom of your device.

Remove the two 8mm Phillips Head screws located at the bottom of your device.

1024

Step 2

Insert the spudger between the two pieces of the case around the media ports and pry them apart.
We found the best way to get the spudger inside the case was to insert in into the SD card slot. Be sure to only insert the spudger a shallow amount and be careful not to damage any of the inside of the device.
Finish unsnapping each plastic piece holding the device together along the bottom.

Insert the spudger between the two pieces of the case around the media ports and pry them apart.

We found the best way to get the spudger inside the case was to insert in into the SD card slot. Be sure to only insert the spudger a shallow amount and be careful not to damage any of the inside of the device.

Finish unsnapping each plastic piece holding the device together along the bottom.

Step 3

Move the spudger down the rest of the case, separating each side, and finally the top.
Pull the back off and place it to the side.
Without a back panel for protection, be sure place your device on the table screen-side down to avoid damaging the internal circuitry.

Move the spudger down the rest of the case, separating each side, and finally the top.

Pull the back off and place it to the side.

Without a back panel for protection, be sure place your device on the table screen-side down to avoid damaging the internal circuitry.

Step 4

              Front Facing Camera

Remove the adhesive padding.

Remove the adhesive padding.

Step 5

Unclip the connector that attaches the camera to the motherboard.
For more information on unclipping connectors see this How To Guide
Do not pull on the camera until you’re sure that it’s unclipped, the gold connection will rip.
Gently pop the camera out of the connector and off the case.

Unclip the connector that attaches the camera to the motherboard.

For more information on unclipping connectors see this How To Guide

Do not pull on the camera until you’re sure that it’s unclipped, the gold connection will rip.

Gently pop the camera out of the connector and off the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Greg Azzalina

Member since: 01/28/2015

263 Reputation

                                      1 Guide authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Penn State, Team 2-25, Kaschak Winter 2015                        

                                                  Member of Penn State, Team 2-25, Kaschak Winter 2015 



                    PSU-KASCHAK-W15S2G25                     


                                            4 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team