Difficulty

Easy

Steps

5

Time Required

                          10 - 15 minutes

Sections

2

  • Back Panel
  • 2 steps
  • Front-Facing Camera
  • 3 steps

Flags

0

  • BackVisual Land Prestige Pro 7D

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Unscrew the two 4.0mm Phillips head screws found near the ports at the bottom of the device using a PH #00 screwdriver.

Unscrew the two 4.0mm Phillips head screws found near the ports at the bottom of the device using a PH #00 screwdriver.

1024

Step 2

  • Be careful when taking the back panel off. The speaker is connected to both the front and back panels, and may get pulled out if you are not gentle when lifting the back panel away.
  • Slide the plastic prying tool in between the front and back panel and pry them apart on all 4 sides.
  • It may be easiest to start on one of the sides, and work your way around the device. The bottom, with the ports, is the most difficult side and can be saved for last.
  • There are small latches that make this difficult. Moderate force may be required to separate the two panels.

Be careful when taking the back panel off. The speaker is connected to both the front and back panels, and may get pulled out if you are not gentle when lifting the back panel away.

Slide the plastic prying tool in between the front and back panel and pry them apart on all 4 sides.

It may be easiest to start on one of the sides, and work your way around the device. The bottom, with the ports, is the most difficult side and can be saved for last.

There are small latches that make this difficult. Moderate force may be required to separate the two panels.

Step 3

              Front-Facing Camera
  • Remove the black pad on the back of the camera by peeling it off.

Remove the black pad on the back of the camera by peeling it off.

Step 4

  • With the bottom of the device facing away from you, pull the camera out of its black housing.
  • The camera will come right out when you lift with your fingers.

With the bottom of the device facing away from you, pull the camera out of its black housing.

The camera will come right out when you lift with your fingers.

Step 5

  • Use the tweezers to lift the grey connector, connecting the camera ribbon to the circuit board, up from the beige housing. It should rotate up, and allow you to slide the ribbon out from under the connector.

Use the tweezers to lift the grey connector, connecting the camera ribbon to the circuit board, up from the beige housing. It should rotate up, and allow you to slide the ribbon out from under the connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Brandon Kodama

Member since: 10/17/2014

229 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 10-41, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 10-41, Amido Fall 2014 



                    CPSU-AMIDO-F14S10G41                     


                                            4 Members                     


                                            12 Guides authored