Difficulty

Easy

Steps

5

Time Required

                          15 - 30 minutes

Sections

1

  • Power Distribution Board
  • 5 steps

Flags

0

  • BackVizio E550i-B2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Distribution Board
  • Place the unplugged television down on a clean surface.

Place the unplugged television down on a clean surface.

1024

Step 2

  • Remove and set aside all 15 Phillips screws.
  • All screws are 13 mm in length, so no sorting is required.

Remove and set aside all 15 Phillips screws.

All screws are 13 mm in length, so no sorting is required.

Step 3

  • There are two speaker wires attached to the back of the TV Panel.
  • Disconnect these two wires.
  • The power distribution board is the larger board and is distinguished by its yellow color.

There are two speaker wires attached to the back of the TV Panel.

Disconnect these two wires.

The power distribution board is the larger board and is distinguished by its yellow color.

Step 4

  • Disconnect the two cables attached to the board.
  • Use the Phillips head screwdriver to remove the seven screws.

Disconnect the two cables attached to the board.

Use the Phillips head screwdriver to remove the seven screws.

Step 5

  • Gently remove the board from the television and replace it with the new board.

Gently remove the board from the television and replace it with the new board.

To reassemble your device, follow these instructions in reverse order.

Once finished reassembling, remember to bring the damaged board to an electronic recycling location.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Nicholas Hughes

Member since: 10/29/2019

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       University of Memphis, Team S3-G2, Willis Fall 2019                        

                                                  Member of University of Memphis, Team S3-G2, Willis Fall 2019 



                    UM-WILLIS-F19S3G2                     


                                            2 Members                     


                                            1 Guide authored

Jay Lott - Nov 22, 2020

Reply

My board looks completely different. The plug the power goes into, is separate from the board, and there appears to be a 3rd board not shown in the instructions.